answersLogoWhite

0


Want this question answered?

Be notified when an answer is posted

Add your answer:

Earn +20 pts
Q: What is creep and what causes it to occur?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Were can creep occur?

Creep occurs on steep mountains.


How does creep occur on a slope?

by the jog speed


What causes computer maintenance in thermal creep?

Cause of thermal creep of the computer maintenance?


Can a creep occur on even very gently slopes?

yes


What is creep in concrete?

Creep is what happens when concrete changes form because of pressure or load on the concrete. It can occur immediately or long term.


How does belt creep occur?

when belt move from tight side to slack side there is some extansion in the belt, and when it again move from slack side to tight side the compression will occur and the change in the lenght of the belt due to which there will be relative motion between belt and pulley and creep will occur.


What causes the seasons to occur what causes the seasons to occur?

it is the tilt of the earth in the suns direction


Where would land creep most likely occur?

A river mouth delta, a volcano by the sea, a drying lake.


Creep is cause by what?

It can be caused by GRAVITY as in the case of old lead pipe sagging. In addition copper contact wires in electrified transport systems sagging under permanent stress causes creep.


What is creep caused?

It can be caused by GRAVITY as in the case of old lead pipe sagging. In addition copper contact wires in electrified transport systems sagging under permanent stress causes creep.


What is the meaning of crept?

of Creep, of Creep, imp. & p. p. of Creep.


How does creep mass movement occur?

creep mass movement occurs where ice wedging takes place.(ice wedging means the ground is freezing and thawing over and over again) As the ground freezes, it expands the water in the soil to push up the sediments. when the ground thaws out all the sediments will fall downslope. Creep is a slow process.