On my 97 neon the radio and interior lights are on a 10 amp circuit breaker located on the under hood fuse block. It is labeled "interior lights". I pull this breaker any time the car sits unused for two days or longer. If this is not done the battery will be drained. I do not have a light stuck on and have tried to locate the drain with no luck except that it is in this circuit.
Dodges are good for blowing fuses. If that is not it, the fan switch might need replaced.
I don't know what year Dodge truck you have but for a good number of years the back up light switch on a Dodge was threaded into the transmission, if it was an automatic. The same switch served as the neutral safety switch.
Jeeps do not use inertia switches.
Sounds like the switch that is in the door frame might be broken. In some cars the switch is in the inside wall of the door frame. You can see it with the car door open. The button gets pushed in as the door closes against it, turning the circuit and the dome light off. Some switches are housed inside a rubber boot that sits in the door frame. I had a truck once with that style switch and it needed a little fiddling to get the light to come on. Its possible that the button on the switch broke off. Then the door doesn't push against the button to turn the circuit off, so the light stays on constantly. A last resort work-around might be to pull the bulb out of the dome light. Then you could have the fuse in to operate the radio and the battery won't drain down, I'd assume.
The answer is simple - You can't fix it! I had the very same problem in the very same vehicle. I also had a Dodge Intrepid with the same exact problem. The evaporator has to be replaced. I dodge dealer will chare you about $850.00 The dash has to be completely removed. This problem seems to be too common with Dodge vehicles. I bought my last Dodge product in 2001 (Grand Carrivan) I will no longer by any Dodge vehicles. Good Luck!
most likely is a faulty chime switch,or a faulty ignition switch
P1789-od/2-4 pressure switch circuit.
Power steering pressure switch circuit performance.
The chime sound comes out of the instument cluster.The chime sound comes out of the instument cluster.
there is no light chime fuse
Trouble code P0703 means:Torque converter/brake switch B circuit malfunction
You have a bad Park neutral switch in the steering column or a problem w/ the circuit. check a wire diagram for this circuit
Trouble code P0572 means: Brake Switch A Circuit Low
Trouble code P0573 means:Cruise control/brake switch A circuit high
Put on your seat belt and buckle it up. The chime will then stop.
* P0521 Engine Oil Pressure Sensor/Switch Circuit Range/Performance
Trouble code P0122 means:Throttle/pedal position sensor/switch A circuit low input