0
What else can I help you with?
What is the dot next to a note on the cello?
The dot next to a note increases its length by half of its original length. For example, the dotted half note. The dot increases the half note's length by half of its original length (which is 2 quarter beats) so the dotted half note is worth 3 quarter beats. It also works on rests. This also applies to other instruments.
What is the difference between a squier bullet and a squier strat?
the main difference between the squire bullet and the squire strat(affinity) are 2 things. size (length wise). for exact specs go to wither guitarcenter.com or go to ultimate-guitar.com and see the reviews for each. they will be under squire. NOT fender. and bullet strats dont have a tremolo system. small difference? affinity has a metallic finish to it whereas the bullet has a more "creamy" coloring. hope this helps
How does a fermata change the value of a note?
A fermata is a pause of unspecified length. It lengthens the original note, but the duration is a matter of feel.
What is the length of a bassoons?
My bassoon is full sized and around 134cm.
On the full-size violin what is the length between the nut and the bridge?
it is about 13 inches.
What is the difference between length and girth?
Length is usually a measure of distance in a straight line. Girth is the distance around a [solid] object.
What is the difference between an arc and an angle?
An angle is measurement use to tell the distance between two lines that are concurrent at a point. An arc is the length of a curve drawn with a unchanging distance (radius length) around a point..
What is the difference between 9mm and 380acp?
Case length.
What is the difference between stress and strain and tension?
Stress is the tension/compression force per unit area.Strain is the ratio of change of length to the original length, due to applied force.Tension is the applied force which tends to elongate the body.
What is the difference between an initial point of a vector and a terminal point?
The difference is the length of the vector.
What is difference between word size and word length?
I don't see any difference.
How do you measure elongation on steel plate?
Elongation on steel plate is typically measured by marking a gauge length on the plate and then subjecting it to tension until it fractures. The elongation is calculated as the difference between the final length of the gauge section and the original length, expressed as a percentage of the original length. This test helps to determine the ductility and deformation capabilities of the steel plate.
What is the Difference between length and long?
I dont know how the long can be explained but length means MEASUREMENT BETWEEN TWO ENDS
What is the difference between length and span of a bridge?
The span is the distance between supports. The sum of the span lengths is the bridge length.
What is the difference in hair length between a 3 and 4 clipper guard?
The difference in hair length between a 3 and 4 clipper guard is typically 1/4 of an inch.
What is the main difference between long and short run?
Their length.
What is is the difference between 1d and 2d?
1d has only the length, but 2d has both the length and width.
