answersLogoWhite

0


Best Answer

Best thing to do is drain in, scrub it, and then refil. I have done the same and time-wise...its a waste. Not to mention all the $$$ in chemicals used. Its best to just pay the water bill. Dump in a 15 pound bucket of pool conditioner (I used EZ Clor) and your pool will stay clear and hardly need any chlorine for the entire season. We add stabilizer 2 times a season to help stop the chlorine from evaporating. That first answer was from someone who is clueless. First, check your alkalinity. If too low (80 or less) than any shock you put in the water will not work and your throwing your money away. Add baking soda (from Sam's $5.50 15 lb) accordingly and then shock it when level of alkalinity is reached. This is a tried and true lesson I learned and saves me a lot of money. If the water is real green to start, use Yellow Out and then follow the above instructions.

Answ:: Water is a precious commodity - use it wisely ~ 25,000 to 40,000 gal. of water is a lot to waste. Besides, draining your pool in many cities could bring a huge fine. You have to be careful with what you add to your pool ~ you can not just indiscriminantly just "throw in" chemicals. There are formulas for just about everything that will go into your pool. You should follow then closely. (plaster pools)......

Firstly, if your filter is dirty, most of the chlorine you add to the pool will be used up in the dirty filter. Clean the filter first, adjust the pH, and in the case above you need to go to what is known as "break point chlorination" essentially a shock but more intensive. You need 10.0 ppm chlor. You have to overcome many things in the water to reach a point where you get a chlorine residual high enough to react to the contaminants. Run filter 24/7. At this point do not worry about your conditioner level until you have cleaned your pool and have backwashed the filter again and have really clear water. At that point return to normal cycle run time - see below. You do need to brush 2 to 4 times per day during the clean-up process to let the chlor react with the algae on the walls and floor. Concentrate on the worst green spots first.

Formula for conditioner is 5# per 10K water. Goal: 50 to 80 ppm cond. Normal filtration times = 8 to 14 hrs per day.

k

User Avatar

Wiki User

16y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: What should you do after shocking your pool 3 times and it is still green and not holding chlorine?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

What level should the pH be when shocking a swimming pool?

a swimming pool it should be neutral pH ie green


How do you get green out of a child's hair from swimming pool?

the chlorine make blond hair turn green. if you use chlorine shampoo it should get it out.


Is chlorine invisible?

No. Chlorine is green.


Is chlorine blue?

Chlorine is a yellow-green gas at room temperature.


What is the colour of chlorine?

the colour of Chlorine is green.


What color is chlorine?

Chlorine is yellow-green in color.Chlorine is a chemical widely used in cleaning products and in pool systems. Chlorine is a yellowish green color. The symbol for the chemical element Chlorine is Cl. Chlorine has also been used as a weapon.Chlorine is a yellow-green colour.


What are the colors of chlorine?

chlorine gas is always green in colour.


What is the color of chlorine gas?

Chlorine gas (Cl2) is a yellowish green in color. It is detectable with ammonia which makes a white smoke when it reacts with the chlorine.


Does all bleached hair go green in chlorine?

not necessarily, it depends how much chlorine you have in your pool. the more chlorine the better you have a chance of turning it green.


What is the color of chlorine?

the color which is produced by chlorine is yellow-green....!! x


Why chlorine is called chlorine?

Chlorine is called chlorine because it is from the greek word chloros which means "lime-green gas"


How do you measure stabilizer in pools?

Stabilizer, in a chlorinated pool, normally refers to the chemical that slows down the rate at which the chlorine leaves the pool. Chlorine is only working while it is leaving the pool, referred to as Free chlorine, as opposed to Total Chlorine. Stabilizer normally takes the form of Cynuaric Acid and is found in all the chlorine products except powdered chlorine. The aim is to ensure it does not leave the pool too quickly. This is why only powdered chlorine should be used for 'shocking' the pool. It provides a high dose of chlorine which dissipates relatively quickly. Pools should be shocked on a regular basis to effectively restart the water balancing process. It is not unusual for the Ph to take a dive after shocking. The main reason for shocking is to get rid of the bacteria which has mutated and become used to the continuous level of chlorine that is not showing much change in level over a period of time. For those of us that use test strips it is referred to as stabilizer or Cynuaic Acid, and a normally good result is in the area of 30-50 ppm. By definition, if it is measured too low then chlorine levels will drop to quickly and tablet consumption may also be increasing to keep up. The other factors affecting the way chlorine leaves the pool is temperature, water agitation and sunshine. Cynauric Acid is cumulative to the pool and the only way it gets out of the pool is by regular back washing, it does not evaporate away. It should also be noted that a high level of Cynauric Acid will stop chlorine leaving the pool and therefore the pool is not being sanitised. It is the answer to the question; 'Why is my pool going green, I have good levels of Chlorine'? - Answer, as above, it's in the pool but cannot get out. Do a partial water change to lower the level of Cynauric Acid and shock it.