exhaust leak
driveshaft center bearing
mudflap/fender skirt rubbing tire
engine mount
Brake rotors or drums need to be machined or replaced. If it causes steering wheel shaking, check front brakes. If happens when applying parking brake look to rear brake problem.
Warped brake rotors. This is a very common problem for the 1999-2004 Grand Cherokees. You will need to have your rotors replaced, or resurfaced. The best resurface method is with an on car brake lathe.
yes they do have antilock brakes
A 1998 Jeep Cherokee has disc brakes in the front.
Live at the Palladium - Turin Brakes album - was created in 2005.
Most times, the squeaking and rubbing noises are caused by brake pad wear, but you say the brakes are fine. Otherwise, if by constant rotation speed you mean the squeaking/rubbing noise is present even when the brakes are not applied, you might want to get the wheel bearing inspected
Check the transmission fluid level for the kicking into gear problem, and check the brakes for the rubbing sound.
sounds like your brake caliper is sticking. This would cause the pads to be in constant contact with the rotor.
rubbing from brakes or rubbing from frame
If the vehicle has hubcaps remove them and see if the noise stops. Check the brakes as well, something on the wheels is rubbing.
The power steering pump also provides power for the power brakes.
Your brakes may be rubbing on the rotor due to issues such as misalignment, worn brake pads, or a warped rotor. It is important to have your brakes inspected and repaired by a professional to ensure safe driving conditions.
Your new bike disc brakes may be rubbing due to misalignment of the brake calipers, a bent rotor, or improper installation.
apply your brakes gently as you accelerate
apply your brakes gently as you accelerate
To adjust bike brakes if they are rubbing on one side, first check if the wheel is properly centered. If it is, adjust the brake caliper by loosening the mounting bolt, centering the brake pads, and tightening the bolt. Test the brakes to ensure they are aligned and not rubbing.
your accelerator is finished (broken)* basically you don't have an accelerate, just two brakes :3