Go to Autozone.com and you can find out what flasher, and where it is located. :)
How to change the brake switch on a 2004 Jeep grand Cherokee Laredo
Yes, he did. Go Light Your World is on the Album "Short Term Memories " (2004)
You don't. Just and fluid and it will go off.
I think you are assuming that to reset the check engine light you can just disconnect the battery. Disconnecting the battery on a 2004 OBD2 compliant vehicle will not reset the check engine light. It must be reset with an OBD2 scan tool. This would work on OBD1 vehicle but not on OBD2 vehicles. So the radio issue is mute. Have the problem that set the check engine light repaired and then reset the light with the tool. Reset the light without correcting the problem and the light will just come back on.
if it is hologen light then it is H7 for both low and high beams
Turn signal flasher is part of the hazard warning module and replaced as a unit
http://www.audiforums.com/m_146946/tm.htm
The Turning Signal Flasher is under the hood in the drivers side fuse box. When you remove the cover from the fuse box you will see the fuses but no relays / flashers. You must then remove a second cover. The snaps are along the side of the box. This will expose the relays and flashers for the 2004 Chrysler Crossfire.
Both fuses # 13 and # 18 are 15 amp fuses for the electronic flashers ( it doesn't show which is the hazards and which is for the turn signals )
pictures of how to change front signal bulbs on a 2004 grand prix pontiac
Light green, the darker green is the right turn signal.
Check Brake fluid level in master cylinder and make sure Emergency brake is fully released
how to change front left turn signal bulb on a 2004 chevy express
The turn signal module is combined with the hazard light module. You need to remove the dash trim to get to it. It is right behind the hazard light switch.
Replace the flasher relay.
it means that you have a bulb out somewhere on your truck.... IE backup light, brake light, turn signal, running light.. etc etc..
Defective flasher module - common problem