It is located at the driver's fender side of the the throttle body.
Its the lock/latch mechanism
A 1996 Jeep does not have a mass airflow sensor.
p0141 is for the sensor behind the catalytic converter.
Two sensors in the same part, yes.
its on the bell housing,on the tranny,driver side.towars the top,held in by one bolt.sets inside the bell housing.
Its the lock/latch mechanism
A 1996 Jeep does not have a mass airflow sensor.
Need a special socket. They are located in the exaust manifold(s).
On a 1996 Jeep Grand Cherokee with a 4.0-liter engine, the coolant temperature sensor is typically located on the engine block, near the thermostat housing. It is usually found on the driver's side of the engine, close to the cylinder head. You may need to remove any engine covers or components obstructing access to the sensor for visibility and removal.
It has 2 wires and screws into the housing that the upper hose hooks to.
The cam sensor is inside the distributor under the rotor.
Where is the windshield wiper relay located on a 1996 grand jeep Cherokee
The oil sensor is located above the oil filter next to the distributor.
No, it uses a MAP sensor (manifold absolute pressure)
Map sensor voltage low.
were is the crankshaft sensor located on a 1987 Pontiac Grand AM with a 2.5L engine
It is bolted on the back of the engine.