0
REMOVAL:
# Raise the vehicle. # Disconnect the switch wire harness connector. # Pry washer lock tabs upward and remove the switch attaching nut and tabbed washer. # Remove the switch adjusting bolt. # Slide switch off the manual valve shaft. INSTALLATION:
# Disconnect the shift linkage rod from the shift lever on the left side of the transmission. # Rotate the manual shift lever all the way rearward. Then rotate the lever forward two detent positions to Neutral. # Install the switch on the manual valve shaft and install the switch adjusting bolt finger tight. Do not tighten the bolt at this time. # Install the tabbed washer on the manual valve shaft and install the switch attaching nut. Tighten the nut to 6.9 Nm (61 inch lbs.) torque but do not bend the washer lock tabs over the nut at this time. # Verify that the transmission is in Neutral. # Rotate the switch to align the neutral standard line with the vertical groove on the manual valve shaft. # Align the switch standard line with the groove or flat on the manual valve shaft. # Tighten the switch adjusting bolt to 13 Nm (108 inch lbs.) torque. # Bend at least two washer lock tabs over the switch attaching nut to secure it. # Connect the shift linkage rod to the shift lever on the left side of the case. # Connect the switch wires to the harness and the lower vehicle. # Check switch operation. Engine should start in Park and Neutral only.
Wiki User
∙ 16y ago
Wiki User
∙ 15y agoNear the top of the Clutch pedal bracket that is holding it all together.
Add your answer:
Earn +20 pts
How do you replace the safety neutral switch on a 1995 Jeep Cherokee 5-speed transmission and Where is the safety neutral switch located?
How do you replace the safety neutral switch on a 1995 Jeep Cherokee 5-speed transmission and Where is the safety neutral switch located?
Where is the neutral safety switch on a 1995 Jeep Cherokee Country?
either behind or in front of the arm of your brake pedal. Follow the brake pedal up until you find a box, either in front of or behind the brake pedal. You will find that the box has a button on it that is activated by your brake pedal, that is the neutral safety switch.
What does the neutral safety switch control in a 2001 jeep Cherokee?
It only allows starting in park and neutral, and runs the reverse lights.
When removing the Neutral safety Switch on a Jeep Cherokee does the trans have to be in Neutral?
Here's a great write up on Neutral Safety Switches in Cherokees http://www.jeepin.com/features/nss/index.asp
What is the weight of a 1995 Jeep Grand Cherokee?
THE WEIGHT OF 1995 JEEP GRAND CHEROKEE IS 1.5 tons to be approximate.
How do you replace the safety neutral switch on a 1995 Jeep Cherokee 5-speed transmission and Where is the safety neutral switch located?
How do you replace the safety neutral switch on a 1995 Jeep Cherokee 5-speed transmission and Where is the safety neutral switch located?
How do you repair a neutral safety switch on a 1995 Jeep Cherokee?
The neutral safety switch and backup light switch are one in the same. You have to replace it. It is located on the transmission where the shifter connects to it.
Where is the neutral safety switch on a 1995 Jeep Cherokee Country?
either behind or in front of the arm of your brake pedal. Follow the brake pedal up until you find a box, either in front of or behind the brake pedal. You will find that the box has a button on it that is activated by your brake pedal, that is the neutral safety switch.
How do you replace a neutral safety switch on a 1992 Jeep Cherokee Laredo?
go to www.naxja.org or www.jeepforum.com and do a search for "neutral safety switch. There will be links to jeep owners sites that have detailed instructions
What does a neutral safety switch do 1998 Jeep Grand Cherokee?
It only allows starting in park and neutral and it turns on the reverse lights.
What does the neutral safety switch control in a 2001 jeep Cherokee?
It only allows starting in park and neutral, and runs the reverse lights.
Where can one find the neutral safety switch on the transmission of a 1996 Jeep Cherokee?
by the shiter lever on the tranny.
Where is a neutral safety switch located on a 2007 Jeep Grand Cherokee?
It is on the valve body inside the transmission.
How do you change the neutral safety switch on a 1999 Jeep Grand Cherokee Laredo 4x4?
the neutral safty switch is located in the trans range switch if you have an aw4 auto trans replace or clean and reinstall the switch
Will 4 WD switch shut down engine on 1995 Jeep Grand Cherokee?
NoNo
If the neutral safety switch is bad would a 1994 Jeep Cherokee stall?
No. It would only prevent you from starting.
How can you bypass the neutral safety switch on a 2002 Jeep Grand Cherokee?
find the conector(s) and jump it. also try starting your vehicle in neutral.
