Might be because the action on the strings is too low,
basically, your strings are too close to your fretboard.
everytime you pluck one it will vibrate against the frets,
try to set them up a bit higher. or turn them a bit tighter,
this might do the trick.
The G string is usually the first to buzz when lowering the action. If this an Electric Guitar, check to see if the buzz is heard through an amplifier. If not, no worries. This is common practice. If it is an acoustic or can be heard amplified, adjust the neck or raise the action (of just the G string if possible).
3 awnswers
1-you are strumming two hard
2-you are not pressing hard enough/low enough on the frets
3-you have a crappy low quality £/$/¥/€60 guitar
Solutions
1-strum softer or without a plectrum
2-push lower/harder on your frets
3-sell it and buy a 100 pound ect guitar or more expensive if you want
your guitar string might be touching your frets. go get your action fixed
The sound hole. If you strum your chord above it it'll make a louder sound.
guitar makes a weird kinda staticy sound when I strum it forcefully
You can, it is just rather quiet. An acoustic guitar is designed to amplify its own sound. This happens because the sound waves travel into the hole in an acoustic, they reverberate and echo out through the hole. An electric (typically) does not have a hole for this purpose, so all you can hear are the strings reverberating. But you can hear it if you strum the string hard.
I believe you've asked this because you've probably seen a picture of an acoustic guitar, which uses vibrations to create it's trademark sound. When you strum a string on an acoustic guitar, the sound bounces back into the inside of the guitar (by going through the 'hole'), and bounces back out to increase sound. This is similar to when you shout into a cave. But no, guitars can be made without the acoustic hole. For example, an electric guitar needs no hole, because it uses an amplifier to create sound; same with bass guitars. you are so dumb.
anywhere on the strings below the nut and below where your hands are on the neck
The player controls the volume of an acoustic guitar through strumming intensity. The acoustic guitar is very dynamic, for louder sound strum harder, for softer sounds strum lighter.
The sound hole. If you strum your chord above it it'll make a louder sound.
You can strum, pick, even tap!
guitar makes a weird kinda staticy sound when I strum it forcefully
You can, it is just rather quiet. An acoustic guitar is designed to amplify its own sound. This happens because the sound waves travel into the hole in an acoustic, they reverberate and echo out through the hole. An electric (typically) does not have a hole for this purpose, so all you can hear are the strings reverberating. But you can hear it if you strum the string hard.
I believe you've asked this because you've probably seen a picture of an acoustic guitar, which uses vibrations to create it's trademark sound. When you strum a string on an acoustic guitar, the sound bounces back into the inside of the guitar (by going through the 'hole'), and bounces back out to increase sound. This is similar to when you shout into a cave. But no, guitars can be made without the acoustic hole. For example, an electric guitar needs no hole, because it uses an amplifier to create sound; same with bass guitars. you are so dumb.
anywhere on the strings below the nut and below where your hands are on the neck
The Guitar changes volume by how hard you strum it. If you are on an Electric Guitar you can control how loud it goes by adjusting a switch. On acoustic as well asstrummingit depends on where you strum it. If you strum it over the Hole in it. It will be louder than if you strummed it up the fret board.
Pluck or strum the strings.
Pluck or strum the strings.
When you strum a guitar, the vibrations create sound. You can manipulate the sound by changing the vibrations.
well the strings need to be held down very tightly so the vibrations canot pass making the sound clear