0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
Why don't they allow scissors in a school cafeteria?
because they might cut the lunch line
What is the next line of lyrics after you d be like heaven to touch?
I wanna hold you so much is the next line. The lyrics are from Frankie Valli's song Can't Take My Eyes Off You. It has been covered by many other artists as well.
Where can you purchase the David Archuleta Life Story Magazine on line?
i dont know but i bought one in walmart for 9 bucks its cheap
Where can you buy a silver bow and arrow that katniss uses in the hunger games in the UK?
look on line or go to a shop where they sell weapons like knives or Bebe guns if you dont find one at either one then i dont know! your welcome
What is the name of the song First line of the song can you feel this and it has other lines that go something like I dont want to feel?
Down With the Sickness-Disturbed
Two line that lie on the same plane but dont touch?
parallel
What are the rules have to be followed to prevent electric shock on man?
On standard low voltages under 600 volts don't be grounded. The bottom line is don't touch the wires.
What is a g shock?
G-Shock is a sportswatch line by Casio that are designed to be water-resistant and shock (impact) resistant.
How do you test fuel pump pressure on 1999 Chevy blazer?
get a fuel pressure tester on the fuel line going to throudle body there is a fitting looks like a valve stem twist off cap screw on the tester . hold tester so you can see it and turn key but dont start the motor if it reads below 54 pounds its bad. check with auto store on pressure to be sure im close.
Are 2 linear pair 2 angles that dont touch each other?
No. A linear pair is formed by a line (hence linear) with one point on the line having a ray which does not match either part of the line. This forms a linear pair, 2 angles with the ray as a common side, so they do 'touch.'
What is used to check for line voltage sags?
just a digital voltage meter measure at the origin, and then at the end of line
How does a line tester work?
The Line Tester or Neon Screwdriver is tools specified for electrical works, though we can use it as Screwdriver in special case. The Line Tester is one of the important tools of electrician. The Line Tester should be a tool of home ‘Tool Box’.Before we learn about the Line Tester we must learn about some common terms and get some basic knowledge of electricity.All Electrical device and appliance use maximum three wires and minimum two wires for electric supply. These wires differ from one another and denoted by specific namesoPhase Wire:This wire is also called as “Live Wire” or “Hot Wire”.oNeutral Wire:This wire is also called as “Cold Wire”oEarth Wire:This wire is used for safety purpose.The Phase Wire in alternating current supply is very important and dangerous. This wire is also called Live or Hot because it has higher potential difference from Neutral or Earth wire. When two different potential wires come in contact current flows in the circuit.The potential difference between two wires or terminals is called ‘Voltage’. In India the potential difference between Phase and Neutral is specified as 220 Volt. While the difference between Neutral and Earth is about 5Volt.Construction of Line Tester or Neon Screwdriver:The Line Tester is tool used to identify the Phase or Live Wire. The main parts of a Line Tester are shown in diagram.1.Metallic Rod:This cylindrical metallic rod is designed as Flat Screwdriver on one end while the other end and major portion of rod remains covered inside the Insulated Transparent Body.2.Resistance:The Resistance is a device which prevents the flow of electric current through it. The resistance of Line Tester reduces the flow of current through it. This resistance makes the tester a safe tool.One end of resistance gets connected with cylindrical metallic rod and another gets connected with the neon lamp.3.Neon Lamp:The Neon lamp is most important part of Line Tester; due to the neon lamp the line tester is also called Neon Screwdriver. The neon lamp is very similar to torch lamp or bulb. One terminal of neon lamp gets connected with Resistance and another terminal gets connected with metallic spring.4.Metallic Spring:The Metallic Spring is used to make connection between Neon lamp and metallic touch screw.5.Metallic Touch Screw:The metallic touch screw is a part of Line Tester which is used to tight all the above components inside the Insulated transparent plastic body and contact with metallic spring connected with Neon Lamp.The outer body of Line tester is made of transparent hard Plastic.Working of Line Tester:When the Screwdriver end of Line Tester comes in contact with the Live/ Hot wire and we touches the rear metallic touch screw a circuit gets completed and the current moves through metallic rod.The metallic rod is connected with a resistance the electric current passes through the resistance. Due to the resistance the great amount of electric current drops and a small amount of electric current passes through it to the next component, viz Neon Lamp and reaches till the metallic touch screw which is in contact of our finger.A small current passes through our body to earth and complete the circuit. As the circuit gets completed a current starts flowing and the filament of Neon lamp starts glowing. This indicates that the Phase of electric supply is present in the touched wire.It is advice to work with electricity only in presence of adult; who has good knowledge to deal with electricity; and take all necessary measures for safe handling of electricity. Never! Never try to work on electricity without proper guidance and care.Precautions:When ever you use a line tester take some precautionsEnsure that the tester is working properly.Ensure that the tester is not broken.Don’t touches the open wire even tester shows absence of phase or hot supply.Never try to test the presence of phase or hot wire of any high voltage supply source the flow of current can be lethal
Will an electric power line shock a person?
Yes it will
How should an air conditioner suction line feel to the touch?
A suction line is usually cold to the touch.
What causes the feeling when you are electrically shocked?
It is the electricity rushing through the line, and when there is an area that is not insulated by rubber, if you touch it, it will shock you. It feels like a moment where you are 'zapped out' you cant breathe and you shake a little, it happened to me, only a little.
How long is a rugby field sideline to sideline?
Touch line to touch line the pitch must NOT exceed 70 metres
Are you out if you touch the line in basketball?
yes
