It could be your batteries in your control. I have a 1996 & mine won't work too great unless I'm 10 feet or closer. Especially the panic, I have to be right next to the vehicle & push it about 8 times before the alarm goes off then I have to push it another 5-10 times to get the alarm to shut off. Will update later if I find solution
No, the XJ Cherokee does not have the same heater box as a WJ Grand Cherokee.
The grand Cherokee is a body style, sport is a trim package that is used on all jeep models(wrangler, Cherokee, grand Cherokee, patriot, ...)
Cherokee Laredo, no. Grand Cherokee Laredo, yes.
Yes
The 2013 Jeep Grand-Cherokee has a V6 engine.
it has to be done by the dealer. =(
the dealer does it with a scan tool
I had the same problem. Google "keyless entry remote 2003 Jeep Grand Cherokee".
YOU CAN FINE ALMOST ANY KEYLESS ENTRY ON EBAY AND FOR A GOOD PRICE.. GOOD LUCK.........
centre top dashboard (red dome)
You have to program it with a DRB (Scan tool).
This works for the 1993 Grand Cherokee: Sit inside the vehicle with all the doors closed. Place ignition in the OFF position. Open the driver's door. Leave Open. Move the mechanical door lever to the LOCK position. Turn the ignition to the RUN position. Aim the transmitter at the Keyless Entry receiver and press Lock button. Hold for five seconds until the door locks cycle. Turn ignition OFF within 20 seconds.
dealer has to do it with factory scan tool
"how do you change a throttle position sensor on a 1998 jeep grand Cherokee?" could someone without any experience do it?
THIS IS FOR A 93 BUT I WOULD THINK IT WOULD think it would also work on that 94.. programming 93 Jeep keyless fob This works for the 1993 Grand Cherokee: Sit inside the vehicle with all the doors closed. Place ignition in the OFF position. Open the driver's door. Leave Open. Move the mechanical door lever to the LOCK position. Turn the ignition to the RUN position. Aim the transmitter at the Keyless Entry receiver and press Lock button. Hold for five seconds until the door locks cycle. Turn ignition OFF within 20 seconds. good luck........
Possible weak battery in the remote.
The keyless entry system must be programmed with an OBD II tool which the dealer or locksmith has. Sorry that this is not the answer your looking for, I didn't want to hear it either.