0
You have a jeep liberty 2003 when you switch to full time drive the car shakes after it reaches 40 mph It is also noticeable in two wheel drive but less?
Wiki User
∙ 18y ago
If you are in Full time it is recommended not to go over 25mph that is probly why it shakes put it in part time you can go up to 55 mph in part time
Wiki User
∙ 18y ago
Add your answer:
Earn +20 pts
Where is the Radiator Fan Relay located on a 2004 Jeep Liberty Limited?
The 2004 Jeep Liberty radiator fan relay switch can be found on the back of the fan motor. The relay switch is attached directly to the fan motor.
How do you reset the fuel inertia switch on a jeep liberty?
Jeep does not use inertia/reset switches.
Why does your radio and odometer light on your 2002 Jeep Liberty get bright and dim intermently?
bad connection in the dimmer control near the headlight switch
Where is the Park Neutral switch on a Jeep Liberty?
If you have the 42RE transmission like I do, there is a picture located here along with a brief description on removing it, it is located on the drivers side right about the transmission fluid pan.
For what is the Power Confort switch 1990 Cherokee Laredo?
This switch changes the behaviour of the automatic transmission; in the Power position, the transmission will shift up and down at higher engine speeds. In the comfort position, the upshift points will be limited, i.e. at Wide Open Throttle the shifts will not be at maximum engine RPM as they will be in Power position. The easiest way to demonstrate this is to drive on a highway at approximately 45MPH (70KPH) and force a kickdown (press the gas pedal to the floor). In Comfort mode, the transmission will shift down into third gear from fourth; in Power mode it will shift down into second gear. The difference is very noticeable. From 1991 onwards, the switch connection at the Transmission Control Unit (TCU) was hardwired in Power mode - no switch.
Is there a kill switch in 2008 Jeep Liberty?
no
How do you replace power steering pressure switch for Jeep Liberty 2003?
Remove the wiring harness from the 2003 Jeep Liberty pressure switch. Remove the power steering pressure switch retaining screws. Reverse the process to install the new power steering pressure switch.
Can you switch a 2002 jeep liberty into 4wd while moving?
yes
Can you reset the oil light in a Jeep Liberty?
The oil light in a Jeep Liberty can be reset. To reset the light turn the ignition switch on or off without starting the engine. Next depress the acceleration pedal at least three times and then switch the ignition switch in a locked position.
How do you turn on foglights in a 2002 Jeep Liberty?
pull out on the end of the lights switch
How do you turn on foglights on 2002 Jeep Liberty?
pull out on the end of the lights switch
Where is the Radiator Fan Relay located on a 2004 Jeep Liberty Limited?
The 2004 Jeep Liberty radiator fan relay switch can be found on the back of the fan motor. The relay switch is attached directly to the fan motor.
You want to turn on a light in your garage when your car reaches a certain distance from the wall?
You need to set up a pressure switch or a motion sensor switch.
What is error code 43 on 94' subaru liberty rs?
Throttle switch error
Where is the oil pressure switch on a Jeep Liberty?
Should be right above the oil filter.
What kind of oil do you use in your 2005 Jeep liberty?
The type of oil that should be used in a 2005 Jeep Liberty is 5W30. You can switch to 10W30 in the warmer months.
How do you reset the fuel inertia switch on a jeep liberty?
Jeep does not use inertia/reset switches.
