The Crankshaft Position Sensor is your problem. Replace this and it'll fire right up.
The coil is on the passenger side of the engine
The 2013 Jeep Grand-Cherokee has a V6 engine.
The 2007 Jeep Grand-Cherokee has a V6 engine.
The 2012 Jeep Grand-Cherokee has a V6 engine.
The 2009 Jeep Grand-Cherokee has a V6 engine.
Engine compartment ne'er the the distributer
The coil is on the passenger side of the engine
Yes, it is on the front passenger side corner of the engine.
A 2002 Jeep Grand Cherokee engine that cranks but is not starting and has no dash gauges is experiencing an electrical system failure. This can be a result of a faulty ignition switch or damaged wiring.
Trouble code P0320 means: Ignition/Distributor Engine Speed Input Circuit
Fuse box, passengers side front of engine compartment, on top of the fender hump.
If the light is not coming on when you turn on the ignition, check the bulb, it may be blown.
If your 1993 Jeep Cherokee continues to run after the ignition switch is turned off, it may be due to a faulty ignition switch or a problem with the ignition system, such as a short circuit. Another possibility is that the engine is experiencing "dieseling," where fuel continues to ignite in the cylinders after the ignition is turned off, often due to carbon buildup or an overly rich fuel mixture. Additionally, check for issues with the fuel system or relay that might be causing the engine to keep receiving power.
On top of the engine..Two black blocks that have wires coming out of it
A 'spark ignition ' engine is your regular gasoline engine as opposed to a diesel, which is a 'compression ignition' engine
Turn ignition to "ON" position. Do not start engine. Depress gas pedal three times in a slow controlled manner within ten seconds. Turn ignition off and then start engine. It should be reset
Diagnostic Code 12 on a 1995 Grand Cherokee just means that your battery has been dead or disconnected within the last 50 ignition cycles.