0
What else can I help you with?
What is the difference between a metal a mineral and an ore?
Mineral,is a naturally occurring material in which metal or its compounds occur.An ore is that mineral in which metal is present in large quantity and from which the metal can be extracted in pure and high quality,economically.
Why might an ore containing a valuable mineral might not be worth mining?
In some cases it will cost more to mine and refine the mineral than that mineral is worth. This can occur if the concentration of the mineral is too low, or if it is buried too deep to be accessed cost-effectively. In this case, the mineral resource is techincally not an ore, as by definition, an ore is a mineral resource that can be extracted at a profit.
Is raw material Direct Material?
the cost of direct materials which can be easily identified with the unit of production. For example, the cost of glass is a direct materials cost in light bulb manufacturing. Hope this helps!👍
What is concentration factor in mineral exploitation?
Concentration factor in mineral exploitation refers to the ratio of the concentration of a valuable mineral in the ore to the concentration of the same mineral in the Earth's crust. It is used to determine the economic viability of mining a particular mineral deposit. A higher concentration factor indicates that the mineral is more concentrated in the ore and thus easier and more cost-effective to extract.
What is a reasonable cost per square foot cooling bill?
A reasonable cost per square foot for a cooling bill can vary depending on factors such as location, energy efficiency of the cooling system, insulation of the building, and local utility rates. On average, a reasonable range could be $0.50 to $1.50 per square foot per month for cooling costs. It is important to consider these factors to determine a specific cost estimate.
What does a book rack cost normally?
Wal Mart is probably the best bet for a book rack at a reasonable cost. They can offer anywhere from 30 to 80 dollars depending on material it is made from and size.
Why is the cost of obtaining some mineral is very high?
Some minerals are found in complex compounds, and it is difficult (and expensive) to separate the mineral from that compound. In other cases, the mineral may be found in remote areas, with greater costs to reach it. In others, the mineral may be buried under great depths of overburden, increasing the cost to reach the mineral layer. The cost of energy and transporting mining equipment to remote areas is greater, and there may be a shortage of labor. And sometimes, the mineral is at a very low ratio of mineral to waste- it will be necessary to mine and remove a LOT of material to recover a very small amount of mineral.
How can one gain rights to copyright material?
If you contact the rightsholder or their administrator, you can often negotiate a license for a reasonable cost. Actually getting the rights themselves is unlikely.
What is a reasonable food cost percentage?
35%
How much should I charge for SAT tutoring?
Consider most SAT prep books cost roughly $45. You are teahcing them and introducing the material, so $30 a session would be reasonable.
Which material is best of insulation?
The best material for insulation depends on the specific application and requirements. Commonly used materials include fiberglass, foam, cellulose, and mineral wool. Factors to consider when choosing insulation material include thermal resistance, moisture resistance, cost, and environmental impact.
Looking into material handling solutions.?
There are wood craftsmen who can build such picnic tables for you which would be beautiful at a reasonable cost. Also, you could contact businesses which are closing and ask them about purchasing their used merchandise.
How does Decrease in material costs impact total variable costs?
If material cost is variable cost then yes by decreasing material cost company can reduce total variable cost.
What are the other inputs in the process of manufacturing in agro based and mineral based industries that involve transportation cost?
Agro based industry include all terms.One input is Raw material-In raw material all includes .Industries may be agrobased,mineral based,mariene based and forest based depending on the type of raw materials they use.
Is Direct Material a product cost?
Yes direct material is a product cost as without material no product can be manufactured.
Is raw material cost variable or fixed costs?
raw material cost variable cost because it change with volume of product i.e. the more you produce the more you have to purchase for raw material. Fixed cost are never change with changing in volume.Raw Material Cost is variable cost
What is the difference between a metal a mineral and an ore?
Mineral,is a naturally occurring material in which metal or its compounds occur.An ore is that mineral in which metal is present in large quantity and from which the metal can be extracted in pure and high quality,economically.
