a rock
This may be known as a scree slope or a talus pile. Talus and scree are normally used interchangeably, however scree normally refers to material of gravel size or smaller and talus to larger debris.
If it's a pile of grass left on the lawn after you mow it, cal it a clump of grass.
snowdrift
The eccentricity of a pile is typically measured by determining the horizontal distance between the pile's centerline and the applied load or resistance. This measurement is crucial in structural design to ensure the pile can safely bear the intended loads without excessive deflection or failure. Eccentricity must be within specified limits to prevent structural issues or stability concerns in pile-supported structures.
To calculate the effective overburden pressure on a pile toe, you would typically need to consider the weight of the soil above the pile toe that contributes to the effective stress. This can be calculated using the unit weight of the soil and the depth at which the pile toe is located. The effective overburden pressure helps determine the bearing capacity and settlement behavior of the pile.
Levees and regoliths.
Point bars are formed on the inside bend of a meandering river where the flow velocity is reduced, causing sediment to be deposited in a crescent-shaped accumulation. As the river flows around a bend, the velocity decreases, leading to erosion on the outside bank and deposition on the inside bank, resulting in the formation of a point bar. Over time, these deposits build up and contribute to the widening of the river channel.
One cubic yard of gravel typically occupies a space of about 27 cubic feet. When piled, it generally forms a mound that's about 3 feet high and covers an area of roughly 9 square feet, depending on the shape and compaction of the pile. The exact dimensions can vary based on the size and shape of the gravel particles.
This may be known as a scree slope or a talus pile. Talus and scree are normally used interchangeably, however scree normally refers to material of gravel size or smaller and talus to larger debris.
It is in a junk pile inside Sully's (to the left).
Pressure 1. On a smooth surface Say your 120lbs. body weight is acting over the whole area of both your feet ( 40 sq, in. say) , this gives 120 / 40 = 3 psi pressure. 2. Standing on gravel Your body weight is resting on a much smaller sum area ( the peaks of the gravel stones) resulting in a painful higher pressure
If we need to separate sand and gravel, we simply use the size of the material and a mechanical contraption to do the separating. A screen with mesh of the proper or appropriate dimensions will sieve the particles nicely. The sand will fall through the mesh piling up underneath it, and, if the screen is tilted, the gravel will bounce its way down and off the screen into a separate pile.
Nausea vomiting dry; itchy skin pile
A moraine is a pile of rocks and dirt deposited in a heap, usually at the end of a glacier. An erratic is a large stone or boulder that has been deposited in a similar way when glaciers retreated, being of a totally different type of rock to that on which it was deposited.
A large pile of rock and debris left by a receding glacier is known as a moraine. Moraines can consist of different sizes of material, from clay and silt to boulders, and are typically deposited along the sides or at the terminus of a glacier.
Gravel has sharp, irregular edges that can dig into the skin, stimulating pain receptors. Sand, on the other hand, has smooth and rounded particles that distribute weight more evenly, causing less pressure and discomfort on the skin.
I don't know what type of dog pile you are talking about, but: Dog pile, as in people all laying on you- get up, or tell them to get off Doggy droppings: Pick them up with a glove, and put them in a bag, then throw them away. If inside, scrub place with a cleaner.