Advantages
a. Better surface finish
b. Better dimensional tolerances.
c. Reduced Machining.
d. Less foundry space required.
e. Low labor costs.
f. Castings require little or no machining.
g. Can be completely automated for mass production.
h. High productivity.
i. Complex shapes can be made as there is no need to withdraw the pattern
j. Very fine details and thin sections can be obtained.
k. Since there is no parting line the dimensions across will not vary.
l. Sand: metal ratios are relatively low.
m.Has better flexibility in design than die-casting.
n. Moulds are lightweight and may be stored for extended periods of time.
Disadvantages
a. The raw materials are relatively expensive.
b. The process generates noxious fumes which creates health problems must be removed.
c. The size and weight range of castings is limited.
d. Poor material strength.
e. High porosity possible.
ADV stands for Adverb.
The main disadvantage of using shells as money instead of coins is that shells are bulkier and heavier, making them less convenient to carry and store. In addition, shells may not have a standardized value or be easily divisible, leading to difficulties in making transactions. Shell currency can also be more susceptible to wear and damage compared to metal coins.
The inner most shell is the K shell with 2 electrons whereas the outer shell or the L shell has 5 electrons
i think it can be used for thermoset moulding and electro-chemical ethching. by okiemute ohwahwa from nigeria.
Maximum number of electrons = 2n2, where n is the number of shell (n = 1 for K, 2 for L, 3 for M, and so on) K shell has 2 electrons maximum L shell has 8 electrons maximum M shell has 18 electrons maximum N shell has 32 electrons maximum O shell has 50 electrons maximum P shell has 72 electrons maximum
Adv. expertise high standing in society trustworthy information flexibility Disadv. no strong economic power no military power
ADV = Avisor Disclosure Vett
What is Adv Technology
its a type of moulding :)
adv. although that could be mistaken for adverb.
A bed moulding is a moulding in architecture of a cornice immediately below the cornea.
bill board adv. who “do u do billboard adv. in this area if not who does”
The resulting moulding with incomplete filling of the plastic resin is called in practice as short moulding.
moulding in agriculture is where scrapped in heaped up around a small surface of a plant
What is 3 benefit for moulding
Joshua Moulding is 6'.
Steven Moulding is 6' 3".