in most options no, wile they may be great for one or two sounds, Marshall has had such a large array of tones and amp lines that make them the most versatile and renounced amp.
At a specific voltage the higher the amperage the higher the rated horsepower of the motor. You will see the amperage rating used when manufactures sell hand tools. A saw that draws 12 amps, it is stated, is better than the saw that draws 9 amps. As the question stands a comparison can not be made between voltage and amps.
In the electrical trade the only time there is a reference to start and running amps is when dealing with motors. The running amps is always lower than the starting amps. A 78 amp electric furnace will take a 100 amp service for it to operate and be within the electrical code guide lines.
Typically 75 amps on natural gas, 85 amps using propane. Peak amps(for less than a second) to start a big appliance, like an A/C condenser, are 130.
The formula you are looking for is I = W/E. 1080/120 = 9 amps. Less than 1. 1080/120 < 1
This refers to the electric current in amps. There is no definition of what constitutes a low current, but in electronics it might refer to less than 1 mA, while in domestic power supply it might mean less than 5 amps.
yes you can but there is more than one marhall so there are in some marshalls but some might not
The higher the better as long as it fits
Higher is better because a speaker will be able to play louder with not as much power. Then you can choose from a wider variety of amps.
Thats really an opinion both brands are good amps and both are tested to show their correct wattage if not more than
On a closed back amp, more of the sound comes out thru the front of the amp, as opposed to escaping out the back of an open back amp.
No.
Slightly more than 11 amps. <<>> I = W/E I = 2500000/220 = 11364 amps
Toys r us,Target,Walmart,possibly Marshalls
GSM provides a better speech quality due to the fact that it is the per user bandwidth that GSM can provide. D-AMPS bandwidth is 24.96 MHz and GSM is 24.8 MHz.
Check the number of amps that your circuit can handle. You should not put devices with more than that many amps (total) on that circuit. Most houses are 15 amps and bathrooms 20 amps.
Typically 75 amps on natural gas, 85 amps using propane. Peak amps(for less than a second) to start a big appliance, like an A/C condenser, are 130.
To make sound louder than it is (Speakers)