A properly selected laser with adequate power can cut a hole in titanium of a suitable thickness.
The SuperStar has the most destructive weapon ever built. Its second most powerful is its laser. The Tentloss DXR-6 Distruptor Laser v.102b (many many upgrades from its original model), powerful enough to blow up a galaxy by firring at its centre.
Possibly but it would have to be a very very powerful laser and the missile would still have to be in the boost phase of flight with plenty of fuel and oxidizer in its tanks (which would be what actually exploded).
Hey there,Blow molding is a manufacturing process by which hollow plastic parts are formed. In general, there are three main types of blow molding: extrusion blow molding, injection blow molding, and injection stretch blow molding. The blow molding process begins with melting down the plastic and forming it into a parison or in the case of injection and injection stretch blow moulding (ISB) a preform. The parison is a tube-like piece of plastic with a hole in one end through which compressed air can pass.- noizyoyster.com
I would say so.
To blow a whistle, put your lips together and blow air through them while holding the whistle in front of your mouth. The sound will be produced by the air vibrating inside the whistle. Make sure to adjust the pressure and intensity of your blowing to control the pitch and volume of the whistle sound.
supreme, Brylcreem, laser beam, wet dream, blow off steam, peaches and cream, don't cross the stream
laser ray and blow up stuff
No, he did not.
There are many ways to cut with a laser. In many cases, a highly concentrated spray of gas or water is sprayed right behind the laser to blow out the recently cut steel, leaving a nice, clean cut. Another method used involves heating the material to its boiling point and vaporizing it; however, this can only be done with materials that do not melt, such as wood. A final method involves cracking very brittle materials with the heat of the laser beam then directing that crack with the heat of the laser beam to make cuts.
you need to replace the high/low beam switch
Blow hole
you have to activate your superpowers and blow up the rocks with your laser vision. ;)
There are many different methods in cutting using lasers, with different types used to cut different material. Some of these methods are vaporization, melt and blow, melt blow and burn, thermal stress cracking, scribing and cold cutting and burning stabilized laser cutting.
The SuperStar has the most destructive weapon ever built. Its second most powerful is its laser. The Tentloss DXR-6 Distruptor Laser v.102b (many many upgrades from its original model), powerful enough to blow up a galaxy by firring at its centre.
Superman would totally win. He would win just with a single blow, ice breath so that it takes Hulk less time to actually kill people and then just beam him with his laser eyes and punch Hulk all the way to Tokyo. They are both heroes and Hulk doesn't kill people.
check your fuses
You blow through it