answersLogoWhite

0

Cutting the power wire on a passtime, or any electronic device, is generally not advisable as it can lead to damage, void warranties, or create safety hazards. If you're attempting to modify or repair the device, it's best to consult the manufacturer's guidelines or seek professional assistance. Always prioritize safety and proper handling of electrical components.

User Avatar

AnswerBot

4mo ago

What else can I help you with?

Related Questions

How do you disable a pass time in a Chevy Blazer?

Find the passtime device , it's usually under the dash near the ignition switch. You can trace it by following the wire from the remote eye. There are 5 wires with a plug connector plugged into the device. Leave the red, pink and black wires alone. The blue wire comes from your ignition switch and goes to a relay switch inside the device. The purple wire comes from that switch to your starter. Leave them cut from the device, but solder, (or connect in some manner) them together so that the passtime device is bypassed. Th enyour starter will get power when you turn the key. That's all there is to it. the passtime device will still appear to be functioning. It will beep and take codes from the remote, but regardless of whether it is timed out or not your starter will still get power. ** I did not want to cut any wires on my Pass Time Elite so i simply put a jumper between the blue and purple wires coming out of the top of the connector on the pass time unit and achieved the same results **


How can I safely and effectively cut cable wire without causing any damage or injury?

To safely and effectively cut cable wire without causing damage or injury, follow these steps: Turn off the power source to the cable wire. Use insulated tools to cut the wire. Wear protective gear such as gloves and safety goggles. Make sure to cut the wire cleanly and avoid any nearby electrical components. Double-check that the power is off before cutting the wire.


How do you reconnect my alarm wire that was cut to silent the alarm?

find the wire and use a wire connector that is the same gauge as the wire.krimp the ends and you should restore power to your alarm.


When was Cut the Wire created?

Cut the Wire was created in 1987.


How do you Connect on and off switch between continuous wire?

First you turn off the power. Then you cut the wire. Strip each end of the cut wire and attach to each side of the switch. This should only be done within a switch enclosure. If there is no extra wire to make a good connection, you can extend the cut ends with wire of the same size as the cut wire and use wire nuts to securely connect the "pigtail" wires. You should only switch the hot side (Black wire in home wiring) and not the white wire which would pose a shock hazard.


Should you cut the red wire or the blue wire?

You Should Cut The Yellow Wire! : D


Can you cut yelow wire 2001 Malibu?

you can cut any wire you choose to cut. i, however, would not cut it.


How do get the power locks to work on a 98 jeep grand Cherokee?

you have a cut wire in the drivers side door wiring, they get opened & closed so much that wires get cut, open the black boot in the door jam & you'll find your cut wire.


What is the best tool to cut wire efficiently?

The best tool to cut wire efficiently is a pair of wire cutters.


Is there a way to bypass passtime?

You can not bypass the passtime. WARNING: if you have passtime and bypass it and the dealer finds out you did they can and most likely repo the car and not refund your money. you signed a contract for passtime when you bought the car.


How do you run a power wire on a 1995 Pontiac sunfire?

what kind of power wire?(a power wire for an amp maybe) what kind of power wire?(a power wire for an amp maybe)


How do you cut clay with cheese wire?

You cut carefully so that the wire does not touch the middle of the clay.