0
Differentiate between a hypo- and a hyperreactor relative to the cold pressor test?
A cold pressor test is used to determine if there is a change is blood pressure
when a subject is exposed to a cold stimulus.
If the subject has a 22 mm/Hg or less change in blood pressure, they are
considered a hyporeactor.
If the subject has a 23mm/Hg or greater change in blood pressure, they are considered a hyperreactor.
What else can I help you with?
What is the difference between a hypo and a hyperreactor relative to the cold pressor test?
A hyporeactor is someone who shows a blunted physiological response (like a slower heart rate or smaller blood pressure increase) during the cold pressor test, while a hyperreactor exhibits an exaggerated response (faster heart rate, higher blood pressure). These reactions can provide insights into an individual's stress response and cardiovascular health.
When do you give Epinephrine after 1st dose of vasopressin in treating cardiac arrest?
after Amiodarone, pressor,antiarrhythmic,pressor,antiarrhythmic
1992 Volvo 940 GL Relay Diagram?
fuel relays & fuel pressor
Labor cost to replace the ac compressor in a 96 cadillac?
Labor. Cost to replace ac com pressor in a 96. Cadillac debille
Hi i got a Honda accord 95 a just put a new clutch kit in it clutch pressor plate and new beering and now when i downshift in 2nd gear it shakes a couple time then it stops what does that shaking?
hi i got a Honda accord 95 a just put a new clutch kit in it clutch pressor plate and new beering and now when i downshift in 2nd gear it shakes a couple time tehn it stops what does that shaking ??
What does a cold pressor test measure?
A cold pressor test is used to measure pain tolerance and pain threshold. The subject places their hand in a container filled with ice water, and gets timed. When pain is felt, the time is recorded. The subject takes their hand out of the water when they cannot bear the pain any longer. This time is recorded. The pain threshold is the first time that is recorded, and the pain tolerance is the time when the hand is taken out of the water minus the pain threshold.
What is a unit of vasopressin equal to in milligrams?
Vasopressin is typically measured in international units (IU), not milligrams. The conversion factor between units and milligrams may vary depending on the specific formulation of vasopressin being used. It is important to consult a healthcare provider or a pharmacist for accurate dosing information.
Where is the distributor cap for your 2000 Jeep Cherokee Sport?
there is not one it has a spark rail on top of the spark plugs tha runs the length of the head on the right side (passenger side ) of the eng starts behind the co,pressor and sotops at the back of the head is held on by 4 13mm bolts
Does raising arms overhead during exercise increase the heart rate?
Raising the arms overhead may decrease heart rate. This is normal and is caused by the change in venous return.
Will the Evaporator Pressor Regulating valve close if the Thermostatic Expansion Valve is in the evaporator air stream?
The EPR valve should work reguardless of if the TXV is in the air stream. The TXV in the airflow shouldn't make it act any different since it is sensing the temperature at the bulb instead of at the valve it's self.
Where is the valve body on a jeep grand Cherokee transmission?
The 1994 Jeep Grand Cherokee ERG solenoid is located on the firewall of the engine compartment. The solenoid will be on the passenger side of the firewall.
Where is a fuel pressure releif valve for a Lincoln mark vii?
You must be talking about the fuel pressor regulator valve? It is located towards the rear of the intake manifold on the fuel rail that is attached to all the fuel injectors. It is a round thing with a vacuum hose attached to the top and is bolted on with 3 small bolts through a flange on the bottom of it...
