Yes.
To create a water cycle project using a hanger, you can follow these steps: Attach a clear plastic bag to the hanger using rubber bands or tape. Fill a small cup with water and place it at the bottom of the bag. Hang the hanger somewhere where it can receive sunlight. Over time, the water will evaporate from the cup, condense on the bag, and then fall back into the cup, simulating the water cycle.
The amoeba does not burst when put in water because it is already full of water. No water can enter the amoeba if it is already filled to capacity.
Yes, rubber seals can typically be placed in boiling water for a short period, as this can help to soften them for easier installation or removal. However, it's important to check the specific type of rubber, as some formulations may degrade or lose their shape when exposed to high temperatures. Always refer to the manufacturer's guidelines for the best practices regarding temperature exposure.
You can affect the extention of a rubber band by putting weights on it. The more weights you put on a rubber band the higher the extention will be.
If you put dried fruit in a cup of water, the fruit would absorb the water and rehydrate, becoming softer and plumper. This can enhance the flavor and texture of the dried fruit, making it more enjoyable to eat.
On your braces brackets there is usually a hook (one on top, one on bottom) which you can put your rubber bands on
Rubber will rot, so all you have to do, is just put it in soil.
To make Silly Bandz with rubber bands, you will need a rubber band, a cookie cutter in the shape you want, and a freezer. You put ther rubber band around a cookie cutter (use tape if needed) and put the cookie cutter in the freezer until the rubber band takes the shape of the cookie cutter.
You probably can, but the rubber bands will break easily and will have to be replaced a lot.
It depends on the Dentist you go to. Some will let you have colored rubber bands for free.
Because it made it pop!
make a foil ball and put rubber bands around it
Rubber bands are made by extruding the rubber into a long tube to provide its general shape, putting the tubes on mandrels, curing the rubber with heat, and then slicing it across the width of the tube into little bands.
You just keep putting the rubber bands around the middle. Put them all in the middle if you can. The pressure will finally be too much. It is best to use one that is smaller and in a little longer and not very round. You need a 'waist' to put the bands around.
first get a clean solid white tee. next twist it. it should be long and skinny. wrap rubber bands along the shirt. if you want thicker strips, put less rubber bands. if you want thinner strips, put more. squirt the dye on the shirt where the rubber bands are not there. let it dry. wash it. and wear it! :)
grab a bunch of rubber bands and put a rubber band over your fist which has the rubber bands and make it tight to where is isn't going anywhere and keep on putting rubber bands around if you can't do it then look up a youtube video...
All this will do is to give you sore breasts. Possibly, if you are allergic to latex, skin rashes in the shape of the rubber bands. And it would be hugely uncomfortable. It will not make your breasts grow.