answersLogoWhite

0

To torque to 70 degrees, tighten the fastener to the specified torque value, then use a torque-angle gauge or a torque wrench with angle indication to measure and turn an additional 70 degrees. This method ensures accurate and precise torque control on critical fasteners.

User Avatar

AnswerBot

1y ago

What else can I help you with?

Related Questions

What is an angle torque gauge?

Some torque specs on head bolts require an additional angle torque after the initial foot pounds (or Nm) has been completed. Example, torque the head bolt down to 70 ft lbs then an additional 90 degrees. The torque gauge measures that 90 degrees for you so you can be accurate.


The torque settings for the cylinder head bolts on a daewoo nubira?

In four stages, 1st with a torque wrench then with an angular torque gauge. Note: when replacing the head gasket, you should replace the head bolts as well.25 n/m (18 lb/ft) + 70 degrees + 70 degrees + 50 degreesin my original daewoo manual says 25n/m +90 degrees+90 degrees+90 degrees daewoo nubira 2.0 2001


What are the head bolt torque spec for a 1.6 Daewoo Lanos?

This is a 3 step sequance and needs an "Angular Torque Gauge" 18 Lb-Ft + 70 derees + 30 degrees. These torque specs came straight from the felpro torque table guide step 1 18 ft lbs step 2 turn all bolts 70 degrees step 3 turn all bolts 70 degrees again step 4 turn all bolts and extra 30 degrees 9 5 1 3 7 10 6 2 4 8


Mains torque specs on a c12 caterpillar engine?

mains are 70 ft lbs plus 90 degrees


What is the torque settings for the head and camshafts on a 2001 Daewoo Leganza?

The head bolt torque specs on a daewoo lanos with the 1.6 liter engine arestep 1 18ft lbs step 2 turn all bolts 70 degrees step 3 turn all bolts additional 70 degrees and step 4 turn all bolts 30 degrees that is what came straight from the torque manual


Whats the torque settings for the cylinder head bolts on a lanos 16 sx?

18 lb/ft +70, +70, +30 Degrees using angle gauge,


What is the cylinder head bolt torque for a 1998 cadillac deville concours with a 4.6 northstar?

1st, 30 ft lbs, 2nd 70 degrees, 3rd. 65 degrees, 4th 4 degrees


Head bolt torque specs on 1991 Chevy 350?

60-to 70 ft. lbs. of torque 60-to 70 ft. lbs. of torque


What is 70 Fahrenheit to degrees centigrade?

70 degrees Fahrenheit = 21.11 degrees Centigrade.


How many degrees f is 70 degrees c?

70 degrees Celsius = 158 degrees Fahrenheit


How warm is 70 degrees Celsius?

70 degrees Celsius = 158 degrees Fahrenheit.


What are the head bolt torque specs for a Subaru impreza 1.6?

This is a Daewoo Lanos site I believe the same 1.6 Lt. engine is used by Subaru if this is true then the following will be correct. This is a three-step sequence and an “Angular Torque Gage is required. 25 Lb.-Ft + 70 degrees + 30 degrees.