How do you change alternator 86 Fiero 4-cylinder?

Answer 1

1.disconnect negative batt terminal. 2.loosen the adjusting bolt and remove the drivebelt. 3.raise the rear of the vehicle and secure it on jackstands and block the front wheels. 4.unplug the connector and the remove the battery lead from the alternator. 5.remove the pivot bolt and loosen the alternator bracket bolt. 6.remove the alternator by lowering it out of the bottom of the engine compartment.

Answer 2

V6 model 1.Loosen lug nuts and hub bolt from right side. 2. Jack up the right side of car and remove tire. 3. Remove lower splash shield. 4. Unbolt your tie rod end by pulling clip out and removing bolt you will need an extractor to get tie rod end out of steering knuckle. 5. Remove brake caliper,pads and mounting bracket. 6. Take your hub nut off and remove strut to steering knuckle bolts. 6. Spray some pb blaster in your hub where bolt came off of pull steering knuckle out and hit the end of your axle spindle out (with rubber mallet) of the hub. support end of axle with wire hung from strut springs. 7. There are two bolts on the inside intermediate shaft remove them and now you can slide out your trans axle(hard parts over). 8. Remove electrical conn. from alternator and take out mounting bolts 2 bolts on bott. 1 bolt on top, top bolt you will need to take the whole bolt out i think the top takes 1/4"socket after you remove bolt . 9. Take plastic piece off the back of alternator 3 bolts 5/16" socket now you can take the alternator out.10. 4 cylinder you dont have to remove axle it comes out of the back. 11. Installation is the reverse. I wouldnt attempt this repair unless you have a mechanical background.

Answer 3

To change the alternator on an 86 Fiero 4-cylinder, first disconnect the battery. Then you will need to remove the drive belt, disconnect the electrical connections to the alternator, remove any mounting bolts holding the alternator in place, and finally replace the alternator with a new one. Reconnect all electrical connections, reinstall the drive belt, and reconnect the battery.

Answer 4

1.) Disconnect the battery 2.) remove the wire frome starter terminals I belive there is 2 nuts and one plug 3.) remove the three retaining bolts 10 or 13 mm depending on style.

Answer 5

You can't. In 1998, there were no F350's.