0
The 2006 International Fuel Gas Code (IFGC) states the following when sizing pipe: G2413.3 (402.3) Sizing. Gas piping shall be sized in accordance with one of the following: 1. Pipe sizing tables or sizing equations in accordance with Section G2413.4. 2. The sizing tables included in a listed piping system’s manufacturer’s installation instructions. 3. Other approved engineering methods. A quick answer is to let the professiojnals do it. Pipe sizing can get a little complicated if you are not using method 2 above. My limmited ability and the format of this board does not allow me to post the equasions needed to properly size pipe. Because gas goes BOOM, it is my recomendation that you find a qualified person to help you size the pipe and then you can install it yourself. Hope this helps Terry
What else can I help you with?
Is there a utility pole standard?
If you want to know the standard for utility poles call your utility company. The electric company set their own standards. There are some required heights for electric cable in the code. For instance they must be no less than 8' above a roof.
How can you measure the ampere or watt for power supply?
You can measure the current and power of a 'power supply', using an ammeter and a wattmeter. With the power supply connected to its load, the ammeter must be connected in series with the power supply's input. The wattmeter's current coil must also be connected in series with the power supply's input, and its voltage coil must be connected in parallel with the supply, taking the instrument's polarity markings into account.
What type of voltage must be passed across a transformer?
A transformer must be connected to an alternating current (AC) supply of the correct voltage.
What must be done to determine the concentration of a non standard solution?
Titrate it with a primary standard
How can you determine that a location on a planet or moon must have had recent geological activity?
There will be few impact craters.
What would the typical short circuit amperage be on a breaker panel with a 1600 amp 240 volt supply and three 400 amp mcc loads?
This rating varies. It depends on the impedance of the utility power supply, so you must obtain this data from the utility before the fault current can be calculated. There is no 'typical' value, since the number depends on a variable that is outside the building's electrical system.
What is the need of maintaining voltage constant at the utility side?
All electrical equipment is designed for a stated voltage range, so the utility company has a legal requirement to keep the supply voltage within a specified range. In the UK it is 230 v -6% +10% so that the voltage must be between 216.2 and 253 volts.
What two things must an item have to have value?
Anything that many want but few have will have high value. Things that are difficult to make often have high value. But for something to have value it must have UTILITY.
Is internet a utility bill?
No, an Internet bill is not classified as an utility bill. An Internet bill would be more for entertainment and not a must have thing.
What does the power supply unit must be toasted mean?
The statement "the power supply must be toasted" is a rather idiomatic way of saying, the power supply must have been destroyed by excess current.
What are the responsibilities of the utility in an easement agreement?
A common feature is that the utility must restore the land to its original condition if it disturbs the area during any installations or improvements. For all the details you must review the easement agreement.
What is output frequency sync to mains?
this always used in inverters and UPS As in standby UPS And line interactive UPS ,the output frequency must be always track the input frequency as it supply the load from utility in standby mode, for any change that will affect the load . as example the frequency of the utility was with permitted values say 58Hz and suddenly the main power cutout, so UPS must be on same frequency so when convert to backup stored power mode ,the load doesn't affected and power continue to supply the load from the batterys through inverter , so output frequency must be always synchronized to utility frequency (mains) in case of any fault happened, hope i answered your question. Sherif Salah R & D Engineer at Arrow Electronics Egypt
What is the process when administrative assistant in large clinic must write a letter to another state to determine whether a physician whom the clinic wants to hire has ever had his license revoked?
An adminstrative assistant in a large clinic must write a letter to another state to determine whether a physician whom the clinic wants to hire has ever had his license revoked. This action is part of a process called?
Explain the interrelationship between property utility and highest and best use?
The interrelationship between the 2 concepts " property utility" and :highest and best use" is simply to attain the highest and best use of a property, the appropriate property utility factors must be taken into consideration. The property must be appropriately supported and financially feasible.
What must you do before you can use the windows backup utility on a windows xp home edition PC?
Backup utility for Home Edition is not included by default. It must be installed manually. Go to \VALUEADD\MSFT\NTBACKUP and double-click the Ntbackup.msi.
When According to the law of supply as the price rises for a good?
supply must go up
What are the assumptions of cardinal utility approach?
Primarily cardinal utility approach has 5 assumptions. 1 rationality: the consumer is rational about his spending. 2 cardinal utility: the utility/satisfaction can be measured in cardinal NOs like 10, 8, 15, 20etc 3 constancy of money: The money of consumer must remain constant. 4 diminishing marginal utility: Marginal/additional utility of consumer decreases along with successive use of any commodity. 5 total utility: Total utility depends on quantity of commodity. 3
