That would be 2,200 psi
1 ton=2,200lbs
PSIG refers to pound/force per square inch gauge, while PSI measures the pressure relative to a vacuum. If you want to convert a figure from PSIG to PSI, you would need to add 14.7psi to your PSIG figure, which will give you your PSIA result.
To convert 14.73 psi to 15.025 psi, you need to increase the pressure by the difference between the two values. Subtract 14.73 from 15.025, which gives you 0.295 psi. Therefore, you can achieve the conversion by adding 0.295 psi to 14.73 psi, resulting in 15.025 psi.
2.3 bar is equivalent to approximately 33.4 psi.
1885.5 PSI
Multiply psi by 0.006894759086775369 to convert from psi to MPa. ex: 1000 psi = 1000 x 0.006894759086775369 = 6.89 MPa http://www.chapelsteel.com/psi-mpai.html
About 4 tons PSI
3 tons is irrelevant to how much psi it is. It depends on what the 3 tons is being used for. PSI is 'pounds per square inch', which is pressure, while 3 tons is just a measurement of weight. They are two totally different measurement tools, so it leaves the question unanswerable. None - one is a pressure, one is a weight - you cannot convert one to the other.
1000 pounds per square inch (ksi) = 6894.76 kPa, so 1 ton (2000 pounds) per square inch = 13789.52 kPa,and 20 tons per square inch = 275790.4 kPa = 275.7904 MPa[megaPascal].I used ConvertWorld to help with the conversions. See related link.20 tons per square inch = 275.790 megapascals20 tons/in2 = 40000 pounds/in2 (psi)Multiply psi by 0.006894759087 to convert from psi to MPa40000 psi * 0.006894759087 MPa/psi = 275.790 (Googled the conversion rate)
The maximum bite force of a great white shark is estimated to be around 1.8 tons per square inch (psi).
130 tons is equal to 260,000 pounds. Pressure is typically measured in pounds per square inch (psi), so the pressure would depend on the area over which the 130 tons is distributed.
figure out the math stupid
If I'm right, it should be around 5,888.7 PSI. That's nearly three tons per square inch!
for NPR max is 4 tons but i suggest you check PSI of the tires if you will load it more than 4 tons or better get a good tires that can withstand the load.
32 tons psi 32 tons psi is a crock, that would be 64000 lbs per square inch. 2000 lbs per ton times 32. The few studies I found, state the psi for a pit bull would be approximately 235. with a Rottweiler being 320. I would think that the original answer was written by someone who doesn't like pit bulls, and can't do basic math.
Concrete is measured in psi "pounds per square inch". Most driveways and sidewalks are anywhere from 3,000-3,500 psi. A state job would be 4,000 to 5,000 psi as they have different standards than your average contractor. Concrete itself can range anywhere from 2,500 to 10,000 psi according to what it's being used for.
Its weights 5300 lbs.. figure it out lol.
There are a lot of strange figure skating moves. Shoot-the-duck is definitely one, but there are tons more.