DISCONNECT THE MOTOR MOUNTS ON THE LEFT SIDE, PLACE JACK UNDER OIL PAN, PUT PIECE OF WOOD BETWEEN JACK AND OIL PAN AND RAISE ENGINE. THIS WILL GIVE CLEARANCE BETWEEN FRAME RAIL AND IDLER. REPLACEMENT IDLERS ARE NO LONGER AVAILABLE FROM Ford, SO YOU HAVE TO KNOCK OUT BEARING AND REPLACE IT WITH NEW ONE. BEARINGS ARE COMMON AT MOST JOBBERS FOR LESS THAN 5 BUCKS. REMOVE SERPENTINE BELT REMOVE IDLER BOLT AND PULLEY, REPLACEMENT IS REVERSAL OF THIS. LOWER ENGINE, TIGHTEN MOUNTS AND YOU ARE READY TO GO.
I need to find out how to replace a fuel pump for a 1993 Mercury Topaz, 4 cylinder, fuel injection
picture on how to replace a water pump for mercury topaz
Is there power to the pump??? If YES, replace the pump. If NO, replace the fuse.
They should be in the front fender well, in the engine compartment.
picture of the fan relay for 1993 mercury topaz
I need to find out how to replace a fuel pump for a 1993 Mercury Topaz, 4 cylinder, fuel injection
picture on how to replace a water pump for mercury topaz
1994 mercury topaz 4cyl
what is the engine?
IF anyone has any imfo on how best to replace an ignition system on a 1993 Mercury topaz please call 714-6383162, or e-mail me at KN657@yahoo.com
Mercury Topaz was created in 1983.
alternator-,ac pump-,steering pump-,crank pully-, idler pulley-,water pump
Is there power to the pump??? If YES, replace the pump. If NO, replace the fuse.
They should be in the front fender well, in the engine compartment.
Follow top rad. hose. It's in that housing.
Horn's should be in the fender wells in the engine compartment.
If the idler pulley is frozen, it is high time to replace the timing belt and the idler. And while that job is being done, consider replacing the water pump and thermostat.