0
How do you wire a two pole lamp holder with a pull chain when you have four wires coming out of the wall?
Assuming the wires are 2 blacks and 2 whites, and assuming one set provides power and the other set continues the circuit downline, you connect both black wires to the black wire of the lamp holder and connect both white wires to the white wire of the lamp holder. Turn the circuit off before making these connections.
What else can I help you with?
How many rods are in a chain?
There are 4 rods in a chain. Each rod is equal to 1/4 of a chain.
WHAT is a four bar chain?
The kinematic chain is a combination of four or more kinetic pairs, such that the relative motion between the link is completely constrained. The simplest & basic kinematic chain is a four bar chain.
How many lead wires are used to obtain a 12-lead ECG tracing?
FOUR
Why 4 wires for dryer?
A dryer needs four wires for proper operation and safety because it requires two hot wires, one neutral wire, and one ground wire. The ground wire helps protect against electrical shocks and ensures proper functioning of the appliance. It is a standard requirement to have all four wires for dryer installations to meet safety regulations.
Can you wire a four way switch with two pairs of two wire?
Yes. You have 2 wires (plus ground) coming from the previous switch in the circuit and 2 wires (plus ground) going to the next switch in the circuit. If you have a neutral, or if you have a switch leg, which would be the conductor from the last switch in the circuit to the equipment being powered, you will need 3 or 4 conductors (plus ground).
How do you connect 15 A 250 v wires to the outlit the are four wires white black red and green from the wall and there are only three screws?
Be sure that those wires coming from the box are for a recepticle and not a light switch.
Where is the coolant temperature sensor on a vw passat 1998 1.8 20v?
it is on the back of theengine with four wires coming out the connector is blue
What is a four letter word holder?
Clip.
How do you keep the chain from coming off on your four wheeler?
It all depends. If the sprockets are good and not bent. And the rear axle is in line with the front sprocket, it might just be a matter of adjusting the axle to take up the chain slack.
Four letter word for flower holder?
Vase
What is a four letter WORD for nosegay holder?
VASE
Where is the back-up switch in a 1966 ford mustang with automatic transmission?
The back up swith also known as the neutral safety switch is located on the side of the transmission and is activated by the shift rod. :: AverageJoeResto.com :: which wire do i hook two it their are two wires coming out of the floor board both black and red and four wires coming from my c4 transmission
How many wires are there in a USB cable?
a usb cable has four wires, two for power and two for communication.
Where is voltage regulator on 1974 cutlass?
There are two options. It may be on the inside fender. It would be a square black metal box with at least four wires coming out of it. The other is it has an internal regulator in the alternator. If the plug on your alternator has two wires side by side coming out (II), it wil have an external regulator. If they are facing each other long ways (--) then it's internal.
Where is the low pressure switch for air conditioning 1998 ford escort zx2?
Behind the passenger headlamp and on top of the accumulator for the A/C system. Looking straight down from the top you'll see the wires exiting the connector. There are two wires coming out of a four pin connector.
Four letter word for fruit holder?
The word is probably bowl.
How many rods are in a chain?
There are 4 rods in a chain. Each rod is equal to 1/4 of a chain.
