A typical blower on high speed can draw around 10-15 amps, but this can vary depending on the size and type of blower. It's important to check the specific product specifications for accurate information.
2 amps
Each computer will have an amperage rating. Using 80% rule for continuous load you should not exceed 16 Amps total. You'll have to add in your monitor power as well. Your start up current can be slightly higher due to bringing discs up to speed. A typical desktop might draw from 2 to 3 amps. Depending on type a monitor may draw from 1 to 3 amps. A typical laptop may draw 1.5 amps from charger.
Assuming a typical lay-in fixture is around 40 watts, it would draw approximately 0.15 amps at 277 volts. It's always recommended to check the specific fixture's specifications for accurate information.
A typical starter motor draws around 50 to 150 amps while cranking an engine. If the current draw is significantly higher or lower, it may indicate a problem with the starter motor or the electrical system.
The amperage a two-speed fan pulls can vary based on its size and design, but typically, a small to medium-sized two-speed fan may draw between 0.5 to 2.5 amps on low speed and 1 to 3 amps on high speed. Larger industrial fans can pull significantly more, often exceeding 5 amps. It's essential to check the manufacturer's specifications for the exact amperage of a specific model.
2 amps
The typical amp draw of a ceiling fan is around 0.5 to 2.5 amps, depending on the size and model of the fan.
About 85 amps for an average import motorcycle. Closer to twice that for a Harley-Davidson.
The typical amp draw of a mini split air conditioning system is around 5 to 15 amps, depending on the size and efficiency of the unit.
Each computer will have an amperage rating. Using 80% rule for continuous load you should not exceed 16 Amps total. You'll have to add in your monitor power as well. Your start up current can be slightly higher due to bringing discs up to speed. A typical desktop might draw from 2 to 3 amps. Depending on type a monitor may draw from 1 to 3 amps. A typical laptop may draw 1.5 amps from charger.
Yes, the blower tends to draw too many amps. Too many amps in the circuit will overheat the wires and connecters and melt them.
Assuming a typical lay-in fixture is around 40 watts, it would draw approximately 0.15 amps at 277 volts. It's always recommended to check the specific fixture's specifications for accurate information.
A typical starter motor draws around 50 to 150 amps while cranking an engine. If the current draw is significantly higher or lower, it may indicate a problem with the starter motor or the electrical system.
The amperage a two-speed fan pulls can vary based on its size and design, but typically, a small to medium-sized two-speed fan may draw between 0.5 to 2.5 amps on low speed and 1 to 3 amps on high speed. Larger industrial fans can pull significantly more, often exceeding 5 amps. It's essential to check the manufacturer's specifications for the exact amperage of a specific model.
1100 watts or about ten amps then another 3 to 4 amps for turn table light and fan
draw a typical storage hierarchy pyramind.
the older furnaces would draw 700 watts plus depending on the size of the blower. the newer furnaces with variable speed blowers can draw as little as 100 watts