There are no natural cones on Mount Kilimanjaro. It is a dormant stratovolcano with three volcanic cones: Kibo, Mawenzi, and Shira.
Male cones produce many pollen grains to enhance its reproductive rate & hence its evolutionary success
Conifers have separate male and female cones to facilitate the process of pollination, which increases genetic diversity and ensures successful reproduction. Male cones produce pollen that is carried by wind to the female cones, where it fertilizes the ovules to form seeds. This two-cone system helps conifers adapt to various environmental conditions and enhances their chances of reproductive success.
Yes, wind is a common method for pollen dispersal in gymnosperms. Male cones produce pollen grains that are lightweight and easily carried by the wind to female cones where they can fertilize the ovules. This wind-mediated pollination allows gymnosperms to reproduce without the need for animals or water.
The reproductive organs of gymnosperms are found in cones, which can be either male (pollen cones) or female (seed cones). The pollen cones produce pollen, while the seed cones contain the ovules where the seeds develop.
about 24 cones
It depends on the prism but cones will always have one.
There is no set number of male cones that can be found in a cluster. Unlike female cones, which are usually single, there can be large numbers of male cones in cluster.
No. You need to have the same vertex angle, or have the same ratio between the height and radius of the cones in order to have similar cones.
There is no set number of male cones that can be found in a cluster. Unlike female cones, which are usually single, there can be large numbers of male cones in cluster.
There is no set number of male cones that can be found in a cluster. Unlike female cones, which are usually single, there can be large numbers of male cones in cluster.
2 cones, try to make it inside!
y * x = Number of cones sold
polyhedrons need flat face and edges, corners which cylinder cones don't have.
That depends upon the relative sizes of the cones and the cylinder.
1
polyhedrons need flat face and edges, corners which cylinder cones don't have.