Portable electric heaters are perfect for heating smaller areas, rooms or garages. There are basically four types: quartz, infra-red, ceramic and wire element. Infra-red heaters have no fan thus no moving parts where the other three have fans to force air past their heating elements. These require no venting and can be used in enclosed areas. They are 100 percent efficient, that is , they output 100 percent of the energy that is input. Unlike vented gas heaters which exhaust a certain percentage of hot gas (energy) outdoors. They are relatively inexpensive to operate. Below is some information on how to calculate the cost to operate an electric heater:
First, you 'll need the Kilowatt Hour rate from your electric bill. This can be found by adding the energy cost and the distribution cost. For example last month mine was .093503/kWh.
Multiply the Watts of the heater (usually found on the back of the unit) by the Kilowatt per hour cost divided by one thousand. Below is an example for a 1500 Watt heater: 1500 W x .093503 kWh / 1000 = $0.14 .This heater would cost about 14 cents per hour to operate or $3.37 a day. That is, if it runs continuously. Most heaters have thermostats and will cycle on and off thus reducing the total cost.
Appliances that can run off 9 kW of electric power include refrigerators, washing machines, dryers, dishwashers, electric ovens, and heaters. It is important to check the power requirements of each appliance to ensure they can be safely operated within the 9 kW capacity.
An electric water heater in a hot tank is called an immersion heater and many of those run at 3 kW with a thermostat to control the max temperature. Power showers use a type of water heater that heats the water at the point where it is used, without a tank. They run at 6-8 kW and are also controlled by a thermostat.
An electric heater is a resistor that dissipates electric power when a voltage is connected across it and a current flows through it. The amount of power in watts is equal to the voltage times the current in amps. Typical space heaters for use in the home are 1.5 kW to 3 kW to heat a single room.
A 5kw heater draws just that, 5kw or 5000 w. If you have that switched on high, well I do not know what your supplier charges per kw hour, I am glad its not me paying.
Just make sure it's well ventilated, with fans if necessary, to take away any heat generated, otherwise there is no need for a/c if it is a room without people in it.
That depends on how long the 1 kW is applied. Please note that kW is a unit of power, not a unit of energy.In general, 1 kW of electrical energy can be converted into 1 kW of heat - if used in a heater. With a heat pump, 1 kW of electrical energy can, in fact, pump several kW of heat energy.
600 KW
200 hp requires about 149kW
Appliances that can run off 9 kW of electric power include refrigerators, washing machines, dryers, dishwashers, electric ovens, and heaters. It is important to check the power requirements of each appliance to ensure they can be safely operated within the 9 kW capacity.
If the town has natural gas for heating, then the power needed per household is between 5 kW and 10 kW. If only electric heat is available, then the combination of electric resistance (auxiliary - from 7 to 10 kW for small residential units) heating, combined with electric clothes dryer (from 2 to 5 kW), electric water heater (from 2.5 to 7.5 kW), and stove (5 kW to 7.5 kW) totaling a min of 15 kW to a max of 20 kW. That would put the max power requirements between 5,000 kW and 10,000 kW. As a matter of reality, a diversity factor of .6 to .7 would reduce the max power to 3,500 kW and 7,000 kW.
2,125 hp equates to about 1,584.6 kW.
3.5 tons air conditioning. 10 Kw electric heat.
40956
KWH = KW times hours If you run a 750 KW load (lights, motors, so forth) for 1 hour, you have 750 KWH. If you run it for 1/2 hour, 750 KW X .5 hours = 375 KWH. If you run it for 5 hours, 750 KW X 5 = you do the math.
An electric water heater in a hot tank is called an immersion heater and many of those run at 3 kW with a thermostat to control the max temperature. Power showers use a type of water heater that heats the water at the point where it is used, without a tank. They run at 6-8 kW and are also controlled by a thermostat.
The kilowatt (kW) requirement to run a garage varies based on its usage and equipment. For a standard garage with basic lighting and outlets, around 1-5 kW may be sufficient. However, if the garage includes heavy machinery or electric vehicles, the demand could increase significantly, potentially requiring 10 kW or more. It's essential to assess the specific electrical needs of the equipment and appliances in the garage for an accurate estimate.
40956