Depends on the resistance of whatever you're trying to run the current through. This is given by P=(I^2)*R
Where P is the power in Watts, I is the current in Amps and R is the resistance in Ohms.
For more info go here:
http://en.wikipedia.org/wiki/Electric_power
A 1 HP motor running at 120 volts will draw approximately 746 watts. This calculation is based on the formula: Watts = Volts x Amps.
Watts = Amps x Volts x Power Factor For a motor the Power Factor is less than 1 and might typically be about .75. For a resistive load like a toaster PF = 1. If you know the Voltage and PF and know the wattage you can calculate amps. Amps = Watts / (Volts x PF)
To calculate the watts, you can use the formula Watts = Volts x Amps. If the voltage is typical at 120V for household outlets, then the trickle charger would consume around 720 watts (120V x 6A = 720W) while operating.
A small shredder 100-200 watts.
To determine the watts needed to run a 12-volt drill charger, you can use the formula: Watts = Volts x Amps. If you know the amperage of the charger, you can multiply it by 12 volts to find the wattage required.
The formula you are looking for is W = I x E, Watts = Amps x Volts.
W = A x V. Watts = Amps x Volts. There is not a voltage stated to multiply the 6 amps with so an answer can not be given.
A 1 HP motor running at 120 volts will draw approximately 746 watts. This calculation is based on the formula: Watts = Volts x Amps.
Watts = Amps x Volts x Power Factor For a motor the Power Factor is less than 1 and might typically be about .75. For a resistive load like a toaster PF = 1. If you know the Voltage and PF and know the wattage you can calculate amps. Amps = Watts / (Volts x PF)
The power consumption of a water softener can vary but typically ranges from 15 to 80 watts during operation. It's important to check the specific power requirements of your water softener model to accurately determine its energy usage.
15 watts
The formula for amperage is I = W/E. Amps = Watts/Volts. As you can see there are two values missing from the question.
To calculate the watts, you can use the formula Watts = Volts x Amps. If the voltage is typical at 120V for household outlets, then the trickle charger would consume around 720 watts (120V x 6A = 720W) while operating.
A small shredder 100-200 watts.
Assuming you mean 12 volts, then you cannot run any 78 Amp fans. Unless your fans run at 0.38 volts, there is no way to draw 78 amps from 30 watts.
10 gauge wire will only run up to 30 amps
To determine the watts needed to run a 12-volt drill charger, you can use the formula: Watts = Volts x Amps. If you know the amperage of the charger, you can multiply it by 12 volts to find the wattage required.