The specific heat capacity of water is 4.184 J/g°C. To raise the temperature of 350 grams of water from 22°C to a higher temperature, you would multiply the mass of water (350g) by the temperature change and the specific heat capacity of water. So, the heat required would be (350g) x (Tfinal - 22°C) x 4.184 J/g°C.
To calculate the amount of heat required to raise the temperature of water, you can use the formula: Q = mcΔT, where Q is the heat energy, m is the mass of water (645g), c is the specific heat capacity of water (4.184 J/g°C), and ΔT is the change in temperature (25°C). Plugging in these values, you will find the amount of heat needed in joules.
Oceans are large areas of water and water does not heat up or cool down as quickly as land does. The reason for this is that water has a higher specific heat than land; it takes more energy to raise the temperature of water than it does to raise the temperature of land. So areas along the coast tend to have weather that does not vary much.
To raise the pH of water to 7 using 25% caustic soda (sodium hydroxide), you need to determine the current pH of the water. Without knowing the initial pH, it's difficult to calculate the exact amount needed. Generally, small increments should be added, and pH should be tested frequently. A typical starting point might be to add about 1-2 ounces of 25% caustic soda, mix thoroughly, and then measure the pH before adding more, since caustic soda is very strong and can quickly raise the pH.
To raise the temperature of 2 kg of water by 1°C, you need 8,400 joules of energy. This is calculated using the specific heat capacity of water, which is approximately 4,200 joules per kilogram per degree Celsius (J/kg°C). Therefore, the energy required is 2 kg × 4,200 J/kg°C × 1°C = 8,400 J.
2
Depends on the rate of flow and the size of the water outlet.
It depends on what temperature is is at and how much water there is.
How much water? What is the gas used?
It would depend on the temperature of the water, or average kinetic energy. (KE) However, what you may be looking for is how much heat is needed to raise the KE, or temperature, of water. 4.184 kilojoules per gram is the heat required to raise the temperature of water 1 degree Celsius.
A back yard pond should only have part day sun, sun helps algae grow and can raise water temp to unhealthy levels, the more shade the better.
It takes 1 BTU to raise 1 lb of water per degree Fahrenheit.
That will completely depend on how much water there is.
42 j
A starting cartoonist should ask for a raise when they deserve it (on merit) or after they have been there a year. If the bottom line of the company has increased rapidly due to your position, then you have every right to ask for a raise.
The answer is 2 calories.
You need to know how what size your pool is. But to raise your salt level 1000 ppm, add approximately 80 lbs of salt for every 10,000 gallons of water. Adjust tequila and lime to taste.