12.5 gauge smooth wire typically has a diameter of about 0.099 inches or 2.52 millimeters.
For a 160' run at 125 amps, you would need at least a 2-gauge wire to minimize voltage drop and ensure safety. It's always best to consult with a qualified electrician to confirm the appropriate wire gauge for your specific situation.
A zero gauge wire can typically handle up to 300 amps of current. However, the exact capacity may vary depending on the specific wire material and insulation used in the wire. It is important to consult the manufacturer's specifications for the wire you are using to determine the exact ampacity.
depending on the insulation type. Most 12 AWG wire will carry that current capacity either. Unless you are running it in the desert or some place extremely hot where derating becomes a factor.
For a 120V 20A motor, you would typically use a 12-gauge wire to ensure it can handle the current without overheating. This wire size is suitable for the amperage and voltage to provide proper insulation and safe operation for the motor.
Yes, no problem at all going to a larger ampacity of wire. Larger size wire yes, smaller size wire no.
The 125 amp wire size chart provides information on the appropriate wire size to use for electrical installations that require a 125 amp capacity. It helps determine the correct gauge of wire to ensure safe and efficient electrical connections.
26 GA. steel is 0.0179 inches thick.
Gauge in floor tile is the thickness in thousandths of an inch. .080 is simply 8 one hundredths of an inch or about 1/12th of an inch thick .125 is 1/8" of an inch so it is 1/8" thick.
For a 160' run at 125 amps, you would need at least a 2-gauge wire to minimize voltage drop and ensure safety. It's always best to consult with a qualified electrician to confirm the appropriate wire gauge for your specific situation.
A zero gauge wire can typically handle up to 300 amps of current. However, the exact capacity may vary depending on the specific wire material and insulation used in the wire. It is important to consult the manufacturer's specifications for the wire you are using to determine the exact ampacity.
depends on its use. If its for residential service its good for 125 amps In commercial and industrial installations it's a bit more complicated but you end up at the same 125 amps.
.125 is thicker than .050
.125
For a 125 amp circuit using THHN wire, the appropriate wire size would be 1/0 AWG.
To convert 125 inches to a thickness measurement, we need to know the unit of measurement. If we assume the unit is inches, then 125 inches is equivalent to 125 inches thick. However, if we convert inches to a different unit such as feet or centimeters, the thickness measurement will vary. For example, 125 inches is approximately 10.42 feet or 317.5 centimeters thick.
The recommended wire size for a 125 amp electrical circuit is typically 2/0 AWG copper wire.
0.125" or 1/8"