To measure the density of a metal bolt, you would first weigh the bolt using a scale. Then, you would measure the volume of the bolt, for example by using a water displacement method. Finally, you would calculate the density by dividing the mass of the bolt by its volume.
A hole that a bolt goes into on a metal part is commonly referred to as a "bolt hole." It is designed to accommodate the bolt's threaded shaft, allowing for secure fastening between two or more components. Proper sizing and alignment of the bolt hole are crucial for ensuring the strength and stability of the assembly.
Both are static electricity.
It all depends on the size of the three items - a metal cube with volume 1 cm3 will weigh far less than one of the bolts they used to attach the space shuttle to the launch pad, correct? And it also depends on the metals in question - an iridium cube will weigh more than a magnesium nut made from the same volume of metal, because iridium is very heavy and magnesium is much lighter. If you had these three objects all of the same metal and they all weighed the same, the cube would be smaller because a cube is a more compact shape than a nut or bolt.
If the density of a solid substance is more than that of a liquid, the solid substance will sink in the liquid. This is because objects with higher density will displace a volume of liquid that has a lower density, causing the solid to sink to the bottom.
To build an electromagnetic crane project, you will need materials such as a battery, insulated copper wire, a metal bolt, a switch, and a power source. Wind the copper wire around a cylindrical object to create an electromagnet, connect the ends of the wire to the power source through a switch, and place the electromagnet near the metal bolt. When the circuit is closed, the electromagnet will create a magnetic field strong enough to lift the metal bolt, simulating a crane in action.
The density of a bolt varies depending on the material it is made from. For example, a steel bolt typically has a density of around 7.85 grams per cubic centimeter, while an aluminum bolt has a density of around 2.7 grams per cubic centimeter.
On a five bolt pattern measure from outer edge of one bolt then across to the middle of another skipping one bolt hole( not quite the diameter). On six or four bolt patterns measure across from bolt center to bolt center as you would the diameter if it were a circle.
10.1
That would be different from bike to bike. Get a vernier caliper and measure it.
Yes.
When a lightning bolt strikes a metal pole, the metal is an excellent conductor of electricity. The metal's free-flowing electrons quickly transport the electrical charge from the lightning bolt down the pole and into the ground, making it an example of conduction.
The Threads on a Bolt are the ridges or grooves that screws into a Nut or into a metal frame or such.
Using a nut and bolt made up of the same metal is preferred in order to avoid corrosion.
With a tape measure.
a good way to remove a metal bolt is to get a screw extractor. You drill a small pilot hole down the middle of the bolt, and lightly tap the extractor into the hole. The bolt will then twist out. You may need to add lube to the bolt if its rusted (WD-40 etc.)
Book of Bolt Action Rifles should help
Hardness