0
Yes, assuming the panel is 460 volt, three phase. You will need to supply a 2-pole breaker of the proper current rating. The breaker installs on any two adjacent phases, such as A-B. Any two phases of 460 volt, three phase power will yield 460v single phase.
IF YOU ARE NOT ALREADY SURE YOU CAN DO THIS JOB
SAFELY AND COMPETENTLY
REFER THIS WORK TO QUALIFIED PROFESSIONALS.
If you do this work yourself, always turn off the powerat the breaker box/fuse panel BEFORE you attempt to do any work AND always use a meter or voltage indicator
to insure the circuit is, in fact, de-energized.
What else can I help you with?
How do you connect a 460V 3 phase motor 60Hz with 380V 50Hz 3 phase supply?
You can use a voltage converter to step down the 460V 3 phase motor to match the 380V 50Hz supply. Make sure the converter can handle the motor's current requirements. It's also advisable to consult with an electrician to ensure safe and proper installation.
How do you connect a 460v 3 phase to a 220v pump?
There are two types of water pumps, submersible and fixed position. Each pump is wired differently from one another. Use the discussion page to state what type of pump you are talking about.
Can you use this switch for three phase incoming and single phase outgoing?
No A intermediate switch can not be used to change three phase to single phase.
Can a single phase motor be wired to a three phase soft start?
No, a single phase motor cannot be directly connected to a three phase soft start. A single phase motor requires a single phase power supply, while a three phase soft start is designed for three phase motors. Using the correct soft start for the motor type is essential for proper operation and protection of the equipment.
What will happen if you use phase to phase voltage for a single phase device?
If a single-phase device is connected to a phase-to-phase voltage, the device may get damaged due to the higher voltage applied. Single-phase devices are designed to operate at a lower voltage compared to phase-to-phase voltage levels typically found in three-phase systems. It is important to match the voltage ratings of the device with the supply voltage to prevent damage.
Can you wire a 460V 1PH motor to any 460V 3PH system?
Yes, as long as you use only one phase of the 3 phase system. If R & Y gives 460 volts, use R & Y. This not a good approach though.
Why does one line of 3 phase 480v show 0 volts and the other 2 have 480?
My first thought is this is probably a corner grounded delta system, but I'm confused by your voltages. If this was a 460v (L-L voltage) ungrounded or corner grounded system, the phase to ground voltage is meaningless, but the phase to phas voltage will be 460v all around the delta. If you have a 460v system and you're only seeing 230v, there's something wrong.
How do you connect a 460V 3 phase motor 60Hz with 380V 50Hz 3 phase supply?
You can use a voltage converter to step down the 460V 3 phase motor to match the 380V 50Hz supply. Make sure the converter can handle the motor's current requirements. It's also advisable to consult with an electrician to ensure safe and proper installation.
Is the type of wiring in most homes single-phase or three-phase?
Single phase.
Two phase instruments?
There is no such thing as a two phase instrument. There is only single phase and three phase. You can only have: single phase/ one pole single phase/ two pole three phase/ three pole
Single phase and three phase circuit?
Yes, there is a difference between single phase and three phase circuits.
What generator size for twin 150 hp 480 3 phase motors 800 amps for a tire shredder.?
First of all, a 150 HP 460V 3-phase motor only draws around 170A, so two of them would only draw 340A, not 800. 340A at 460V equals almost 300,000 watts (or 300kw), and the generator would need to be sized a little bigger than this to start such big motors.
How do you convert a 3-phase system to a single phase?
By having a transformer with 3 phase input and single phase out put
How single phase preventer working?
working of single phase preventor
How do you connect a 460v 3 phase to a 220v pump?
There are two types of water pumps, submersible and fixed position. Each pump is wired differently from one another. Use the discussion page to state what type of pump you are talking about.
What is the advantages and disadvantages of single phase and three phase?
Single phase inherently requires less equipment (it's cheaper). Three phase motors are more efficient than single phase.
How do you derive three phase single way?
3 phase /sqrt(3) * 30 degree phase shift = single phase.
