The two systems of measurement include the English system based on the foot measurements, and the Metric system which is based on the Meter as the standard unit of reference.
A mercury thermometer, that is a barometer can be used to measure vapor pressure. Initially, a proper temperature must be recorded. Then the liquid should be injected into the mercury column. This new measurement subtracted from the original will yield the vapor pressure of a liquid.
No. A light-year is a measurement. A light year is a distance measurement based on how far light travels in a year.
The meniscus rule is used in chemistry to accurately measure the volume of a liquid in a graduated cylinder. It involves reading the bottom of the curved surface of the liquid level to get a more precise measurement.
Yes, measurement involves quantifying attributes of objects or phenomena using numbers based on a standard unit of measurement. This allows for consistency and comparability in expressing quantities.
embedded system also include microcontroller.
yes
MGL is a liquid measurement, lead based paint is measured in ppm or mg cm3.
jayega bhitar
MSASM is a good tool
To convert ml to cc (cubic cm) replace the ml with cc. ml and cc are the same thing. 1 ml = 1 cc Millilitres is the new SI (Metric) measurement of volume, based on a liquid measure of a litre. Cubic centimeters are based in the same SI system but are no longer an SI standard measurement of liquid.
A subjective measurement is something that is based on an opinion and is most often biased. The opposite would be an objective measurement which is quantifiable and based only on fact.
The element law of a capacitor in frequency domain is based on Ohm's Law, which is capacitance times voltage is equal to current. The higher frequency, the lower the capacitance and vice versa.
well a liquid cannot be a solid but i will interpret the question as this: what is the relationship between the units of measurement for the volume of a liquid and a solid? liquid volume- measured in mL solid volume- measured in cm cubed 1 mL=1cm cubed
Check the links! Microchip's Application Notes are a good place to start.
ULN2003 is used where the current rating and voltage rating of a motor or any load which is to handled by microcontroller is more than the current handling and voltage handling capacity of that microcontroller. A pin of ULN2003 can handle 600 mA current. It can withstand voltage upto 50 volt. A pin of any microcontroller can handle current upto 200 mA and controller voltage is around 5 volt. So we use uln2003 in parallel to any microcontroller to drive heavy load devices. Uln2003 accepts TTL from MCU which may be 5v or 0v and depending on this value ULN2003 turns on the heavy load or turn it off respectively. for more inquiry mail me at grv_sh@yahoo.co.in
Dogan Ibrahim has written: 'Using LEDs, LCDs, and GLCDs in microcontroller projects' -- subject(s): Information display systems, Automatic control, Liquid crystal devices, Light emitting diodes, Microcontrollers 'Microcontroller projects in C for the 8051 family' -- subject(s): C (Computer program language), Intel 8051 (Computer), Programmable controllers, Programming 'Microcontroller based applied digital control' -- subject(s): Data processing, Design and construction, Digital control systems, Microprocessors, Process control 'SD card projects using the PIC microcontroller' -- subject(s): Computer storage devices, Programmable controllers, Programming, Microcontrollers 'Microcontroller projects in C for the 8051' -- subject(s): C (Computer program language), Intel 8051 (Computer), Programmable controllers, Programming, Intel 8051 (Microcontroller), Microcontrollers 'PIC BASIC' -- subject(s): Design and construction, Integrated circuits, Microelectronics, Programmable controllers