10 nos
The size of the wire is set by the maximum current it has to carry. The voltage sets the size of the insulation. In the UK a 230 v (nominal) ring-circuit supplying a set of power sockets is rated at 30 amps and uses a ring of 2.5 sq-mm cable.
A parallel circuit provides a path for current to flow to wall sockets and appliances in a home. In a parallel circuit, each device is connected in a separate branch from the power source, allowing current to flow independently to each device. This setup allows appliances to operate independently and provides a safety feature where one device can still operate if another fails.
Did you mean "maximum RESISTANCE" or "maximum VALUE"? If the former, then, you have a ZERO reading, meaning there is high resistance, and no electrical connectivity. If the latter, you have a ONE (or 100%) reading, meaning there is NO resistance, or absolute electrical connectivity. As an analogy, if you turn on a plugged-in, working, lamp, then it has NO resistance, such that power flows easily through the cord; if it didn't turn on, then there IS resistance, such that no power flows, possibly due to broken wire, bad switch, burned-out bulb, or blown fuse.
Mains sockets are electrical outlets designed to connect devices to the power supply. They provide access to electricity for devices such as lamps, appliances, and chargers. Mains sockets are typically found in homes, offices, and public spaces for powering various electrical devices.
This cannot be answered without knowing what size load you are connecting to the circuit. In the absence of a load, with a dead short, you will get a flow of amps at the maximum that the power supply can provide. I have no way of knowing what that is.
Are you getting power to sockets? Make sure you have a good ground circuit
the circuit which has the maximum power output
Maximum power transfer happens in a circuit when the resistance of the circuit equals the reactance. Impedance Z = R + jX. At R=X, maximum power transfer happens.
The value of the half-power frequency in the circuit is the frequency at which the power is half of its maximum value.
The size of the wire is set by the maximum current it has to carry. The voltage sets the size of the insulation. In the UK a 230 v (nominal) ring-circuit supplying a set of power sockets is rated at 30 amps and uses a ring of 2.5 sq-mm cable.
when all the resistance removed from the circuit
50%
P=I2R=(59mA)2(8.2kohms)= 28.5443W
It is define as twice the maximum symetrical short circuit current.
XL=Xc is the resonance condition for an RLC circuit
The cutoff frequency in an RL circuit is the frequency at which the output signal power is half of the maximum power. It is significant because it determines the range of frequencies that can pass through the circuit effectively, affecting the overall performance and functionality of the circuit.
I have seen power adapters that have at least 10 sockets. That will give you plenty of room for space!