Grounding
Article 250 of the National Electrical Code covers grounding.
The National Electrical Code (NEC) article that covers using a cord and plug as a disconnect for a clothes dryer is Article 625. Specifically, it addresses the requirements for cord-and-plug connections for appliances, including dryers, emphasizing that they must meet specific safety and installation standards. Always consult the latest edition of the NEC for the most accurate and current information.
The National Electrical Code (NEC) addresses electrical appliances primarily in Article 422, titled "Appliances." This article outlines the requirements for the installation, wiring, and safety of various types of appliances, including fixed and movable equipment. It also covers specific provisions related to the grounding, disconnecting means, and overcurrent protection for appliances. For detailed guidance, it's important to review the specific sections within Article 422.
The minimum size conductor for industrial branch circuits is typically addressed in Article 210.19(A) of the National Electrical Code (NEC), which provides guidance on conductor sizing for branch circuits. It's important to refer to the specific version of the NEC that is currently adopted in your location, as code requirements may vary.
The article designations may change with the code cycle year. In the 2005 NEC see table 310-16 (allowable ampacities for conductors), also article 240.4(D) (protection of small conductors), also table 210.24 (summary of branch circuit requirements for muti-outlet branch circuits)
Article 250 of the National Electrical Code covers grounding.
In NEC 2005 Article 310.10, Conductors for General Wiring it warns that conductors in close proximity to rooftops may experience a temperature rise of 17C (30F) above ambient. It goes on in detail and is referred to throughout the NEC.
NEC, Article 336 covers the use, installation and construction specifications for nonmetallic-sheathed cable. Nonmetallic-sheathed cable may be used for either exposed or concealed wiring.
Article 134
Article 92
Article 134
Article 86
No Article 210 in the NEC
Article 92
Article 134
What article of the UCMJ covers fraternization
The minimum size conductor for industrial branch circuits is typically addressed in Article 210.19(A) of the National Electrical Code (NEC), which provides guidance on conductor sizing for branch circuits. It's important to refer to the specific version of the NEC that is currently adopted in your location, as code requirements may vary.