a measuring cylinder is a scientific apparator used to measure the amount of liquid in which is needed.
dum you
An instrument used for measuring a quantity of something is called a measuring device or a measuring instrument. Examples include a scale for measuring weight, a ruler for measuring length, or a thermometer for measuring temperature.
When measuring one point to another point you are measuring distance.
Measuring glass is used for measuring the amount of liquid.
A scale is typically used for measuring weight. It can be a bathroom scale for measuring body weight or a digital scale for measuring the weight of objects.
The boy measuring stick said to the girl measuring stick, "You're way ahead of me!"
5.7 liter caboretter compretion an 8 cylenders in a "v" shape
5.7 liter caboretter compretion an 8 cylenders in a "v" shape
I beleive that is the number of cylenders which effects the power it can put out.
I should be equal on all cylenders and about 110 to 120
Right down the center of the Kia is where the plus and ignition cylenders are. There are 2 ignitions. Remove the center panel right on top of the kia. Then remove the two ignitios in the holes below the cylenders you will find the plugs. Yoe will need an extension to get them out!
A z-28 is a camaro that has a high performance motor that consists of 8 cylenders. The motors push out 275 to 305 hourse power from factory.
a v8 engine is in a shape of a "v" where is a straight 8 engine all of the cylenders are all inline in a shape of an "I".
ignition timing is the time when your spark plugs fires the gas in the engine cylenders usually tdc or top dead center on the #1 cylender
i have a 1988 Chevy with a 350, it stalld at stops sometimes too. what you should to is check the compression of all the cylenders, they should be 145-160, if there are any low then that could be your problem. I checked mine and cylenders 3 and 5 were at 60 and 100. This means either the rings are bad or the valves. what i did was rebuld th eupper half of motor, the valves were all bad,and there was blowby between cylenders 3 and 5, causing low compression, meaning motor cant hold it own, truck runs good now.
it is because it is running on 5 cylenders or 3 cylinders depending on the motor
You apply a measuring stick or a measuring tape.You apply a measuring stick or a measuring tape.You apply a measuring stick or a measuring tape.You apply a measuring stick or a measuring tape.
it is a prism, just cut so each side is a square. a prism is basically a shape where 2 ends are identical, but the math teacher says this excludes cylenders, or cans.