The hole numbers on the top of each element represent the atomic number. This number indicates the number of protons in the nucleus of an atom of that element. It is a unique identifier for each element on the Periodic Table.
No, dark matter is not a black hole. Each one is a separate cosmic phenomenon. Use the links below to find out about each one.
You would have a black hole the size of the combined mass of the two black holes.
Currently (2009dec23), there is no hole in the ozone layer at either pole. The maximum ozone hole size occurred in 2006. So it appears it is no longer growing.See "How did the ozone hole occur?" in the "Related questions" section below.
No, mercury cannot be absorbed by a black hole. Black holes are massive objects that can absorb anything that crosses their event horizon, but mercury is a chemical element and cannot be absorbed in the literal sense.
No, the ozone hole is not permanent, but does reappear every year. The hole over each pole is only there for a short time each year, during that pole's winter. Lack of sunlight is the cause of this hole.
Its the average of the weight of the different isotopes of that element.
The numbers on a harmonica typically represent the holes that you can play notes from, with each hole corresponding to a different pitch. For example, in a diatonic harmonica, the numbers indicate which hole to blow or draw air through to produce specific notes. In instructional materials, these numbers help players identify where to place their mouth to achieve desired sounds or melodies. Additionally, they can also indicate chord patterns or specific techniques in harmonica playing.
yes because square numbers have to be hole numbers to be square
it be poodie hole. that be da element name for ammonium. boy you dumb as heck . dumb ask mudah fudah. ash hole.
When I was young my teacher did this to us and the answer was hole in one (i didn't get it)
1,2,3,5,6,10,15,30
A record with multiple holes is typically referred to as a "multi-hole record" or a "hole punched record." These records are often used for specific applications, such as in voting systems or data storage, where each hole can represent different pieces of information. The presence of multiple holes allows for the encoding of more complex data compared to standard records with a single hole.
if the bottom number of each denominator is 1 or 0 than it will always be a hole number. when you are comparing the both denominator must be the same.
Each chip has one hole.
To mark off a 5-hole flange, start by drawing a circle with a compass or a scribe to represent the flange diameter. Divide the circle into five equal sections using a protractor or by marking angles of 72 degrees (360°/5). From each division point, draw radial lines to the center to indicate hole locations. Finally, mark the desired hole diameter at each intersection point and ensure all markings are accurate before drilling.
To read the numbers on a belt, first locate the measurement markings, usually in inches or centimeters, which indicate the belt length. These numbers typically start from the buckle end and represent the distance to the first hole. Ensure the belt is laid flat to see the markings clearly, and remember that the length is usually measured from the buckle prong to the center hole for proper fit. If you're unsure, compare the belt with a size chart or measure your waist to find the right size.
In Bingo Bango Bongo, the player who had the best score on the previous hole tees off first on the next hole. If there is a tie in scores, the player with the lowest score on the previous hole goes first. This format adds a strategic element to the game, as players strive to perform well to earn the advantage of hitting first.