The three faults are.... 1. Normal 2. Reverse 3. Strike-slip
No. Your terminology is close but not quite right. The three main types of faults are normal faults, reverse faults, and strike-slip faults. Strike-slip faults may also be called transform faults.
The three types of faults are normal, reverse, and strike-slip faults. Normal faults are associated with divergent plate boundaries, reverse faults with convergent plate boundaries, and strike-slip faults with transform plate boundaries.
There are strike- slip faults, normal faults, and reverse faults. A strike slip fault is where the ground moves past each other. A normal fault is where the plates move pull apart and the plates move up and down. A revers fault is where the plates push into each other and move up and down.
A three-phase symmetrical fault exists when all three line conductors are short-circuited, sometimes to earth (ground). An unsymmetrical fault occurs when only one or two of the three lines are involved.
Reverse faultNormal faultStrike-slip fault
The three types of faults are Normal faults, Reverse faults, and Strike and Slip fault
No. Your terminology is close but not quite right. The three main types of faults are normal faults, reverse faults, and strike-slip faults. Strike-slip faults may also be called transform faults.
The three major types of faults are normal faults, reverse faults, and strike-slip faults. Synclines are not faults but rather geological structures that describe the folding of rock layers.
Faults are surfaces along the earths crust in which rocks have been fractured and displaced. There are three types of faults: strike-slip, normal and reverse.
three kinds of faults are normal fault, reverse fault, and strike-slip fault.
The three main types of fault lines are normal faults, reverse faults, and strike-slip faults. Normal faults occur when rocks are pulled apart, reverse faults form when rocks are pushed together, and strike-slip faults happen when rocks slide past each other horizontally.
The three types of faults are normal, reverse, and strike-slip faults. Normal faults are associated with divergent plate boundaries, reverse faults with convergent plate boundaries, and strike-slip faults with transform plate boundaries.
refuse
the three types of faults are normal (colliding), reverse (moving apart), strike-slip (sliding past each other)
convergent plates produce thrust faults divergent plates form normal faults transform plates form strike/slip faults
The three main types of faults are normal faults, reverse (or thrust) faults, and strike-slip faults. Normal faults occur when the crust is extended, causing one block of rock to move downward relative to another. Reverse faults happen when the crust is compressed, pushing one block up over another. Strike-slip faults involve horizontal movement, where two blocks slide past each other laterally.
Describe the three types of plate motion and the faults that are characteristic of each type of motion.