The load connected to the charger creates a current to flow from the charger to the load.
The charger with the 900ma output will charge the battery faster than the charger with a 500ma output. The phone with the 900mah battery will last longer between charges than that of the 500mah battery.
Light bulb in the home - alternating current (A/C) Light bulb in a car - direct current (D/C) Output of a battery charger - direct current Input of a battery charger - usually alternating current
Yes, you can charge a 500mA battery with a 1300mA charger. The battery will only draw the amount of current it needs for charging, so it will not be harmed by the higher current output of the charger. However, make sure the charger voltage matches the battery's voltage requirement.
Normally speaking, the output of a charger is stated in milliamps mA (ie 500mA) and the term mAh refers to the number of milliamps flowing for 1 hour. So for example, a 1000mAh battery will need to be charged at 500mA for 2 hours to reach full charge. In your case, I must assume that yours is a 500mA output charger and is suitable for charging an 8.4 volt battery. Theoretically at this current output, your charger will take about 9 hours to charge a 4300mAH battery. In practice the process is not 100% efficient so a 10 hour charge will probably be required.
Yes it could be possible. There are two parameters that have to be met. You will need a 12 volt DC submersible heater. The wattage of the heater must be low enough so as not to draw more amperage than the battery charger's output can supply. The formula to use would be I = W/E. Amps = Watts/12. An example would be, for a 120 watt heater, A = 120/12 = 10 amps. If your battery charger has a higher output than 10 amp then you can make the battery charger heat water.
The power output of a 5V/2A charger is 10 watts.
7.5v 500mA Dc charger
No.
A 5V 2A charger outputs 10 watts of power.
No, because you didn't actually ask a complete question. I want to make a charger that output 12v 5amp out put.
A: that is no standard or establish output from each charger. However the charger must provide the maximum current necessary to charge the battery and the voltage must always be more then the battery when has reached full charge
Depends on what you are charging and the output of the charger. That is why an automatic charger is always best. No chance of overcharging the battery.
Charger Output Voltage versus Battery VoltageNO, the output voltage of a charger must be greater than the rated voltage of the battery, usually at least one and a half to two volts difference.
The output of an electric fencer is a high voltage pulse of DC voltage.
The one with the output of 5v 800ma as this will charge devices quicker and overheat less.
250
3.5L high output