Heading indicates the direction the ship/aircraft/vehicle you are in is moving toward.
Bearing is normally used to indicate the direction something else is relative to you.
The ship was heading 085 and maintaining a station on the carrier at two miles and a bearing of 200 from the carrier.
This is often the case where a ship or airplane is "pointed" on a bearing across the wind or current and "moving" on a heading that is the natural consequence of the combined forces on the hull.
The definition of a true compass bearing - A true bearing is measured in relation to the fixed horizontal reference plane of True North, that is using the direction towards the geographic North Pole as a reference point.
See this website in the link below
True magnetic bearing is the angle measured clockwise from true north to a destination point. It takes into account the magnetic declination, which is the difference between true north and magnetic north at a specific location. This type of bearing is important for accurate navigation using a magnetic compass.
The compass rose commonly used in cartography designates the east as having a bearing of 90 degrees to align with cardinal directions. This system provides a standardized way to indicate direction on maps and coordinates.
It is usually referred to as "bearing" but laymen would use "heading" or "direction" They can also be called the "cardinal" directions
compass bearing 271
The compass bearing of south is 180 degrees
Bearing cross reference refers to the bearing on a compass. There are many types of bearing crosses on a compass, and their productiveness solely depends on the material of the bearing cross needle.
The AXIUM hand bearing compass is manufactured by Delite ApS, Copenhagen, Denmark.
It is a bearing (a direction) based on a magnetic compass reading.
To input a negative bearing into a compass, first convert the negative bearing into a positive angle by adding 360 degrees (if necessary) to bring it within the 0-360 degree range. For example, a bearing of -30 degrees becomes 330 degrees. Then, align the compass to this positive angle, using the compass housing to set the desired bearing. Finally, use the compass to navigate according to the adjusted angle.
The definition of a true compass bearing - A true bearing is measured in relation to the fixed horizontal reference plane of True North, that is using the direction towards the geographic North Pole as a reference point.
on a compass a bearing is a measure of north south east and west
the answer is east.
180 degrees
The compass direction of travel.
A compass bearing of 135 degrees points southeast.