answersLogoWhite

0

When you wind a current carrying wire into a coil, it causes the concentration of the magnetic field line to intensify. Depending on which pole of the magnet is in the up position, the wire will move towards or bend away from it.

User Avatar

Wiki User

17y ago

What else can I help you with?

Continue Learning about Natural Sciences

Does the ground wire on a 200 amp panel need to be looped through both ground rods?

No, the ground wire on a 200 amp panel does not need to be looped through both ground rods. The ground wire typically needs to be connected to the grounding electrode system, which may include ground rods, but it does not need to loop through them. It is important to follow local electrical codes and guidelines when installing grounding systems.


How alternating voltage is generated in a coil of wire when it is rotated between the poles of a magnet?

Electical current.=============================Answer #2:When a coil moves in the vicinity of a magnet, a voltage between the endsof the coil is produced. If the coil happens to be part of a closed circuit, thenthere could be an electrical current.Answer #3When a coil moves through a changing magnetic field, a voltage is produced, and when a resistor is connected to the coil some current flows and power is produced in the resistor. This power comes from the mechanical power needed to push the coil through the magnetic field when it carries a current.


Why doesn't my snow blower throw snow as far anymore?

Either your coil is shot or your kill switch is stuck closed. If you warm it up (above freezing) and it still doesn't have spark, bet on the coil being bad or if you are lucky, the sparkplug wire is cracked and grounded. you can isolate & test the coil by removing the engine shroud, you will find one thin green or black wire going into the back of your coil, disconnecting this wire will isolate the coil from the rest of electrical system. recheck spark with the wire disconnected, if you still dont have spark you need a new coil, if now have spark it means your coil is working and either a switch or a bad wire is grounding the system.


How do you wire a 230 volt contactor with a 110 volt coil?

To wire a 230 volt contactor with a 110 volt coil, you need to connect the 110 volt power supply to one terminal of the coil and the neutral wire to the other terminal of the coil. Ensure that the contactor is rated for use with a 110 volt control circuit. Additionally, verify the wiring diagram provided with the contactor for proper connection details.


What are the arrangement of moving magnets and wire coil called?

electromagnet

Related Questions

What happens insider generator?

A coil of wire spins in a magnetic field


What is a strong short lived magnet created by a looped electrical current?

A strong short-lived magnet created by a looped electrical current is an electromagnet. When an electric current flows through a coil of wire, it induces a magnetic field around the coil, which can attract or repel magnetic materials. Turning off the current will cause the magnetic field to cease.


What happens to the coil of wire when someone presses the switch?

If the coil is connected to a circuit and the switch is closed then, provided there is a power source, the coil will become energized.


What happens when you run electricity through a coil of wire?

Running electricity through a coil of wire will create a magnetic field around the wire. This phenomenon is known as electromagnetism. The strength of the magnetic field can be increased by increasing the current flowing through the wire or by adding more coils to the coil.


Where is the coil wire located on a 1997 Chrysler Sebring LXI 2.5L?

The coil is inside the distributor. There is no coil wire.The coil is inside the distributor. There is no coil wire.


What happens when electric current passes through a coil of wire?

When electric current passes through a coil of wire, a magnetic field is generated around the coil. This phenomenon is known as electromagnetic induction. The strength of the magnetic field is directly proportional to the amount of current flowing through the coil.


Is coil a type of wire?

yes coil is a type of wire


Which wire goes to the coil on a Honda nsr125 1998?

The coil wire.


Where is location of coil wires 8N ford tractor?

The coil wire runs from the coil to the center of the distributor cap.The coil wire runs from the coil to the center of the distributor cap.


Where is the coil wire on a 1995 Buick Riviera?

There is no coil wire. There is a coil pack and connected to the coil pack is the ignition control module.


What would cause the coil wire to burn out at the coil end of the coil wire on my 93 Toyota Camry?

Toyota Camry coil wire can burn out from age or excessive use. The manufacturer recommends that you change the coil wire every 30,000 miles.


Moving a magnet in and out of a coil of wire produces an?

electric current in the coil of wire.