answersLogoWhite

0

Is a big and strong wave that cleans, or destroy everything when it pass through.

User Avatar

Wiki User

13y ago

What else can I help you with?

Related Questions

What is the homophone for sweep?

tow, toe sail, sale wave, waive tract, tracked


How do you get the blanket out of the leaves on great pumpkin island?

Click on the leaf pile, then wave your cursor back and forth to sweep the leaves away.


What is the future tense of sweep?

The future tense of sweep is "will sweep" or "is going to sweep."


What is the present infinitive of sweep?

The present infinitive of "sweep" is "to sweep."


How is frequency of an electromagnetic wave measured?

The wave is amplified electronically and applied to either an oscilloscope ,where the trace is drawn on a calibrated graticule using a known timebase sweep, or it is applied to an electronic timer that counts the time for one complete cycle of the unknown wave and displays the result digitally as Hertz by means of a frequency meter.


How is frequency measured on an oscilloscope?

Frequency is, in general, measured on an oscilloscope by looking at the display and making a small calculation. By determining the number of "units" a cycle of an observed wave takes up on the screen and incorporating the sweep rate as set by the operator, you can find the frequency. To do this, look at the signal. Increase the vertical sensitivity to make the wave "take up most of the screen" without chopping any of its amplitude off. Center the signal vertically in the display. Then adjust the sweep rate to get more than one but less than two complete cycles of the wave on the display. Now count the number of "units" on the graticule from the "start" to the "end" of one complete cycle. Lastly, take the horizontal sweep rate from the dial and apply that to the number of units you counted on the graticule. The sweep rate will be in time per graticule unit. Multiply this by the number of units that you counted for a cycle. You'll calculate the total time per cycle from this information. What you will actually get is the period of the wave. It will be the time it takes for one complete cycle of the wave. The period of the wave is the time per cycle of the wave. With the period, you can simply invert it to find the frequency in cycles per second (Hertz). Seconds per cycle inverted is cycles per second.


What is the voltage sweep generator?

sweep generraators


What is flueologist?

a chimney sweep


Sentence with the word sweep?

The intent of a whirlwind romance is to sweep your intended right off of her feet. Please sweep the front porch. How can you sweep with that old broom?


What is difference in Alternate mode triggering and Chop mode triggering?

These are the 2 triggering modes available in a CRO. In alternate triggering mode, the first horizontal sweep is reserved for the first channel to output the waveform, the second sweep for the second channel and this keeps alternating. This is suitable when sweep time is small or else we may observe flickering of signals in the display [This is because, during a sweep, one of the channel is inactive and thus its output clears off in a certain time( remember phosphorescent coating)]. In chopped mode, during a sweep, parts of the output wave are drawn in both the channels in an alternating manner, the frequency of which is kept high to provide in-sensitiveness to human eye. This works well for higher sweep times.


What is the syllable for sweep?

The word "sweep" has one syllable.


How many syllables are in sweep?

Sweep has one syllable.