Single pole toggle switch.
That is called a 4 way light switch circuit. On each end of the circuit you install a 3way switch and in the middle you install a 4 way switch.Answer using British TerminologyIn the UK, 'three-way' switches are called 'two-way' switches (more logical, if you think about it!), and the 'four-way' switch is called an 'intermediate' switch.
You will need a three-way switch setup, where one switch is installed in the first location and another switch in the second location. This will allow you to control the lamp from either location independently. Both switches need to be connected to the same circuit, with one acting as the primary switch and the other as the secondary switch.
The separate on-off switch for a lamp is called a "lamp switch" or a "light switch." It allows you to easily turn the lamp on or off without having to unplug it from the outlet.
You can if you have a neutral wire present. If the existing switch is what is called a "switch loop" then you can not change the existing switch to a switched outlet. You can identify a switch loop by looking at the wires coming into the switch bow. If there are only one set of wires usually a black and white and they go directly to the switch then you have a switch loop
You turn on two switches wait 5 min. and turn one of the switches off! go in the next room the cold one belongs to the switch you never turned on..the warm one the switch you only left on 5 min and the lite one to the switch that is turned on! you switch on one switch for a few minutes, one for ages, and dont turn the other one on at all. you go through to the other room, the bulb that is warm is operated by the first switch, the roasting hot bulb (that would burn your hand) is operated by the second switch, and the cold bulb is operated by the third switch.
Morph
A device that opens and closes a circuit is called a switch.
transit
because one layer is the electrical part, and the other layer is the place where the switch is on.
not that i know of, but there is one that has them switch bodies can't remember what it called but just browser inuyasha and kagome switch bodies.
A rotary switch.
pickup selector switch
That is called a 4 way light switch circuit. On each end of the circuit you install a 3way switch and in the middle you install a 4 way switch.Answer using British TerminologyIn the UK, 'three-way' switches are called 'two-way' switches (more logical, if you think about it!), and the 'four-way' switch is called an 'intermediate' switch.
The switch will have two termination points at the top or one side called the line side of the switch. The corresponding bottom or other side of the switch will be called the load side of the switch. Terminate the two wires from the distribution breaker to the line side of the two pole switch. Terminate the motor to the two terminals on the load side of the switch. On a motor switch there should be a place where an overload protection can be screwed in. Order the overload heater element to the sizing of the amperage on the motor's nameplate rating.
yes it does, however it is not called a Hold switch its called a Sleep on/off switch, and its not really a switch its more of a button that you press.
it is called a reciprocol
There is no one.