accepted density is a part of the equation of the percent error... i.e. :
experimental value- accepted value/ accepted value x100% = percent error
The accepted density range of oak is typically between 0.6 to 0.9 g/cm^3.
the value used for a substance's properties accepted by everyone
The density of an electron is its mass divided by its volume. The rest mass of an electron is approximately 9x10-31 kg. The size, however, is much more difficult to determine as an electron is not a rigid ball - instead it is more like a wave, with diffuse edges. An approximate accepted size for an electron is 5 × 10-13 m, giving a it volume of 5x10-37m3. These figures give a density for the electron of approximately 1700 tonnes/m3, a density that is 154 times that of lead
Mass and volume are extensive properties, which are dependent upon the size of the sample. A larger sample will have a greater mass and volume than a smaller sample. Density is an intensive property, which does not depend on the size of the sample. Density is a ratio of mass to volume, which does not vary with the size of the sample. The density of a larger sample will be the same as the density of a smaller sample.
Water's accepted density is 1.00 g/mL at standard temperature and pressure so depending on temperature the 1057 grams of water will occupy just about 1057 mL.
The accepted density range of oak is typically between 0.6 to 0.9 g/cm^3.
1g/mL
The conclusion of a density experiment would typically involve comparing the calculated density value to a known or accepted value to determine the accuracy of the measurement. If the calculated density is close to the accepted value, it indicates that the experiment was successful and the substance was identified correctly.
Percent error refers to the percentage difference between a measured value and an accepted value. To calculate the percentage error for density of pennies, the formula is given as: percent error = [(measured value - accepted value) / accepted value] x 100.
The density percentage error is computed through this formula; percentage error equals in the observed value minus the accepted value over accepted value times 100 percent. Density is the quantity of mass of a substance measure per unit of volume through the formula density is equal to the quotient of mass and volume.
Density ------------------------------------------------------------- The density is measured in SI by kilogram/cubic metre (kg/m3). Also g/cm3 is used but is only an "accepted" unit.
the value used for a substance's properties accepted by everyone
In terms of a market price, there is not an accepted value for iron. The price is not fixed.
The percent error in the measurement of density is calculated by taking the absolute difference between the measured value and the accepted value, dividing it by the accepted value, and then multiplying by 100. The result is rounded to the appropriate number of significant figures.
the density of balsa wood ranges from 40 to 340 kg/m^3....moreover the typical density is stated as 160kg/m^3...however most people use the debsity as 200kg/m^3 I suppose for calculations purpose
The density of a liquid should be consistent and reproducible across multiple measurements to ensure that the data are good. Typically, the density should be close to the accepted value for that particular liquid at a given temperature and pressure. Deviations from this value could indicate errors in the measurement or experimental setup.
In science, and most specifically chemistry, the accepted value denotes a value of a substance accepted by almost all scientists and the experimental value denotes the value of a substance's properties found in a localized lab.