proton wira ..95 Ron
A dashpot check valve controls the flow of fuel in a carburetor. If it is bad, it can cause issues with fuel delivery and negatively impact engine performance, potentially leading to the generator not running properly. It's best to have the dashpot check valve inspected and replaced if necessary to ensure the generator operates smoothly.
yes,methane is a good fuel as it does not pollutes environment
A P0449 code on a Chevy Avalanche typically indicates a problem with the evaporative emission control system vent valve/solenoid circuit. This may result in issues with fuel vapor escaping from the fuel tank. It is recommended to have a professional diagnose and repair the issue to prevent potential fuel system problems.
The best butane lighter fuel is often considered to be triple-refined butane, as it produces a clean and consistent burn with minimal impurities. Look for brands that clearly specify their butane as triple-refined for best results.
you need a new carburetorOR you might want to take it off and clean it. It might just be in need of a good cleaning.Somethin Else To TryBefore you take off the carburetor, you might want to check the setting. Sometimes, the vibration will cause the needle valve to vibrate open or closed. Here is the procedure for setting the caruretor:The following procedure applies to all small enginesIf the engine does not start:(1) rotate the carburetor main jet needle valve clockwise (close) until it touches its stopping point - DO NOT FORCE OR GO BEYOND THE POINT OF TOUCHING as it may damage the tip.(2) Rotate the needle valve counter-clockwise (open) 1-1/4 to 1-1/2 turns - this should be close enough to start the engine. Start the engine and let it warm up about five minutes.(3) Rotate the needle valve clockwise (close) slowly until the engine starts to stall for lack of fuel, then rotate the needle valve counter-clockwise (open) slowly until the engine starts to stall from flooding (too much fuel).(4) Set the needle valve to a midpoint between the two extremes for the best "purr" of the engine. If the engine "sputters" when a load is added, open the needle valve an extra 1/8 turn for a slightly richer mixture.If the engine starts and you just want to adjust the carburetor, steps (1) and (2) are not necessary.
in the tank, same unit as the fuel pump, it is a bad design
2.0S B20A3: 2L SOHC 12 valve with dual-sidecraft carburator, 104hp@5800rpm 111lb-ft@4000rpm 2.0SI B20A5: 2L DOHC 16 valve with PGM-Fuel Injection, 135hp@6200rpm 127lb-ft@4000rpm 2.1SI B21A1: 2.1L DOHC 16 valve with PGM-Fuel Injection, 140hp@5800rpm 135lb-ft@5000rpm
I have a Astra F '97 1.4 litre DOHC 16 valve engine Average 6.5 to 8.5L/100km or 33 to 43 MPG (imperial)
should be on the fuel rail
in 100 degree weather mines loves premium appx 2200 feet 2.5 dohc
it is part of the fuel valve. there is a filter element on the inlet of the fuel valve in the tank.
on the end of the fuel rail
On a Ford F-250, the fuel tank valve is typically located near the fuel tank itself, which is usually situated under the truck bed towards the rear. The valve is part of the fuel system and may be integrated with the fuel pump assembly or located on the fuel lines. For specific access and identification, it's best to consult the vehicle's service manual or a repair guide.
Not sure what a fuel shut off valve is on a 2000 Lesabre. There is a fuel pump relay, a fuel pressure regulator, a fuel pump, fuel injectors, a fuel filter, but no fuel shut off valve.
There isn't a fuel shutoff valve.
What's does the fuel valve do on a 49cc dirt bike
Regular unleaded is probably best for it! For info, the fuel filter should really be replaced with the service every 35,000 miles.