answersLogoWhite

0

The interlock is used to prevent the service supply and the generator supply from being inadvertently paralleled to each other.

User Avatar

Wiki User

11y ago

What else can I help you with?

Continue Learning about Natural Sciences

How do you lock a fuse box in a residential home?

Generally the fuse box is housed in the house electrical switch board located on the outer wall of the house. Since the switchboard also houses the supply authority meter to record electrical use, the supply authorith needs access to the meter in the switch board. Accordingly the supply authority will only allow the use of a lock to which they have a master key. Usually the supply authority will supply a lock (At a small cost) with which to lock the switch board


What electrical safety procedure is described below If you are going to work on something electrical you should first disconnect it completely from its electrical source Then you have to make sure tha?

Lock Out, Tag Out This is the process of disconnecting the power supply, locking it so no one can turn it back on and tagging the lock so people know why it is locked out and who locked it. It is against the law in some states and OSHA for someone else to unlock it.


What is the strongest monsuno?

The strongest Monsuno is generally considered to be Lock, due to its versatile abilities and high power level. However, the strength of a Monsuno can also depend on the skill of the user and how well they can strategize and utilize their Monsuno in battle.


How do you connect a 4 prong generator twist and lock and 4 wire cable to a 3 prong transfer sw receptacle?

Generally, the screws that the wires go on are color coded. The two hot wires(black & red) go on the brass colored screws, the white goes to the silver screw, and green goes to the green screw. There are many variations on the configuration of the plug, so no answer would be foolproof. There should be some kind of diagram that came with the plug though. It would also be best to turn off all breakers to the load, and check for proper voltages when the generator is running before turning breakers back on and using the power.


How would you wire a generator 120V 240V 4 prong twist-lock outlet to a 3 wire 1 hp 240V well pump?

First off you must make sure that your generator has overcurrent protect. This comes from article 445 in the NEC. Then size your wires accordingly. Then hook up your 2 hots, neutral, and ground, making sure you use wire that is listed for a wet location. Your pump will need a disconnect along with overcurrent protection.

Related Questions

How do you break a power divider in a differential?

do not ingage inter axle lock when spinning wheels.


Where is the inter lock relay on a 1994 Nissan Pathfinder?

should be under the hood in the power distrabution box


Is the power divider and inter axle lock the same?

Power divider and interaxle differential are two names used to describe the same thing. The lock simply ensure that both outputs from the power divider always rotate at the same speed.


What does the inter lock switch on Nissan trucks do?

Inter-lock usually means in any truck, is to lock the differential. When locking the differential, it literally locks the rear axles allowing for both tires to spin at the same time. Most differentials with out a lock system will alternate witch tire has more power making the other one just roll.


How do you connect a 4 prong generator twist and lock plug to a 3 prong travel trailer power cord?

Check Lowes and Home Depot they normally carry the adaptors


Where is the Transmission shift inter lock solenoid on a 2007 Chrysler Sebring?

It is inside the shifter.


Power lock fuse for town and country van?

The power lock fuse for your Town and Country Van can be found in the fuse box. The power lock fuse will be in the second column, fourth from the top.


Should the backdoor lock with the power lock on my 02 Durango?

Yes


Power lock does not work in 1998 Mercedes Benz slk230?

Check the fuse, if power lock fuse is burnt, replace it.


1994 Oldsmobile 88 power door lock fuse location?

were is the power door lock relay on a 1994 olds 88


What are the best way to guard against vapor lock and overheating?

Supply of fuel (Gasoline or CNG) should be stopped. Try to start the vehical with no fuel supply. It will comsumed the pressure build up due to Vapor Lock & engine will start. Then after engine star , you can open the fuel supply.


What are the parts and function of LCD projector?

lcd projector,lock quote,generator,keybord,mouse projector and screen projector