bandwidth
The "ip ospf cost" command can be used to manually set the cost of an OSPF-enabled interface. The "bandwidth" command can indirectly affect OSPF metric calculation by adjusting the bandwidth on an interface, which in turn affects the OSPF metric calculation.
Germany, in line with the rest of the world except the U.S., uses the metric system.
Turkey uses the Metric System.The only country that does not use the Metric System is the USA.
Yes, Italy uses the metric system for measurements like distance (kilometers), weight (kilograms), and volume (liters). The metric system is widely used throughout Italy for consistency and ease of communication.
Yes, Switzerland, along with every country in Europe, uses the metric system.
The "ip ospf cost" command can be used to manually set the cost of an OSPF-enabled interface. The "bandwidth" command can indirectly affect OSPF metric calculation by adjusting the bandwidth on an interface, which in turn affects the OSPF metric calculation.
OSPF stands for open shortest path first. OSPF is an exterior routing protocol. OSPF uses Path vector routing algorithm.
RIP RIPnetworks are limited in size to a maximum of 15 hops between any two networks. A network hop with a hop count of 16 indicates an unreachable network. The other routing protocols do not use the hop count as the metric, EIGRP uses bandwidth and delay for the metric. OSPF and IS-IS use a relative link cost, BGP uses paths, rules, and policies for the metric.
OSPF uses cost as its routing metric . cost is calculated for every outgoing interface of a router through which packets transfer. it is calculated by the formula cost = 100000000/(bandwidth of output interface) most likely bandwidth of serial int is 1544kb= 1544000 bytes PS: all cost calculation to be done in bytes for ease
we would need to redistribute ospf routes into eigrp and vice versa. redistribution will have to be done on an ASBR(autonomus system boundry router) eg: we have an ospf process wid process id 10 running and eigrp with ASN 20 running in our network redistribution on ASBR would be conf t router ospf 10 redistribute eigrp 20 subnets metric 1 and in eigrp conf t router eigrp 20 redistribute ospf metric 1 1 1 1 1 we see i used 5 ones in eigrp process to redistribute opsf into eigrp. thes 1's are metrics for eigrp namely load bandwidth delay reliability
Both uses Distance vector algorithm...... . updates the routing table for every 30 seconds. and in OSPF requires hoping reneval of routing table
It depends on the routing protocol in use, for example RIP uses the hop-count to determine the best route where less hops is better, OSPF uses cost, EIGRP uses a composite metric (BW + Delay + Reliability + Load) etc.
Anyone who uses the metric system.
OSPF LSA throttling helps the dampening of LSA updates in OSPF during times of network instability.
OSPF is short form of open shortest path first. OSPF is based on linked state routing.
The metric system
OSPF is short form of open shortest path first. OSPF is based on linked state routing.